2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com Contents Safety information Setting and starting a washing programme Product description Control panel Washing programmes Use of the appliance Care and cleaning Setting the water softener What to do if…...
3 Safety information For your safety and correct operation of • Always close the door when you do not the appliance, read this manual carefully use the appliance to prevent injury and not before installation and use. Always keep to stumble over the open door.
4 electrolux • Do not use the appliance: • Do not drill into the sides of the appliance – if the mains cable or water hoses are to prevent damage to hydraulic and elec- damaged, trical components. – if the control panel, worktop or plinth...
5 Control panel On/off button Programme selection buttons Delay start button Digital display Indicator lights Function buttons Indicator lights Programme-in-progress – Comes on when you select a washing programme. – Stays on for all the duration of the washing programme.
6 electrolux Indicator lights Comes on when it is necessary to fill the salt container. Refer to 'Use of Salt dishwasher salt'. After you fill the container, the salt indicator light can continue to stay on for some hours. This does not have an unwanted effect on the operation of the appliance.
7 If you use combi detergent tablets ('3 in 1', '4 in 1', '5 in 1', etc.), refer to the chapter 'Multitab function'. Setting the water softener The water softener removes minerals and • French degrees (°TH). salts from the water supply. Minerals and •...
8 electrolux 6. Press the function button A one time to 7. Press the on/off button to save the oper- increase the water softener level by one ation. step. Use of dishwasher salt Caution! Only use dishwashers salt. 4. Remove the salt around the opening of Types of salt that are not applicable for the salt container.
9 during the subsequent washing pro- gramme. 4. Close the rinse aid dispenser. Adjusting the rinse aid dosage The rinse aid is set at the factory at position You can set the rinse aid dosage between position 1 (lowest dosage) and position 6 (highest dosage).
Page 10
10 electrolux • Plastic items and pans with non-stick coatings can keep water droplets. Plastic items do not dry as well as porcelain and steel items. • Put light items in the upper basket. Make sure that the items do not move.
11 Maximum height of the dishes Upper position 20 cm 31 cm Lower position 24 cm 27 cm Do these steps to move the upper basket to the upper position: 1. Pull the basket out until it stops. 2. Carefully lift the two sides until the mech- anism is engaged and the basket is sta- ble.
12 electrolux 4. If you use detergent tablets, put the de- tergent tablet in the detergent dispenser (A). 2. Fill the detergent dispenser (A) with de- tergent. The marking shows the dosage: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent.
13 • Press and hold the two multitab buttons 5. Press function button B. (function buttons D and E). The multitab – The indicator lights for function buttons indicator light comes on. A and C go off. To deactivate the multitab function: –...
Page 14
14 electrolux Interrupting a washing programme Cancelling a delay start: 1. Press and hold function buttons B and C Open the door. until: • The programme stops. – All the programme lights come on Close the door. – The programme-in-progress indicator •...
15 Washing programmes Washing programmes Programme Degree of soil Type of load Programme description Intensive Heavy soil Crockery, cutlery, pots Prewash and pans Main wash up to 70°C 2 intermediate rinses Final rinse Drying Crockery, cutlery, pots Prewash Automatic and pans Main wash up to 45°C or 70°C...
16 electrolux Care and cleaning 5. Hold the coarse filter (A) by the handle Warning! Switch the appliance off before you clean the filters. with the hole. 6. Remove the coarse filter (A) from the mi- Cleaning the filters crofilter (B).
17 What to do if… The appliance does not start or stops during Caution! Switch off the appliance operation. before you do the below suggested If there is a fault, first try to find a solution to corrective actions.
18 electrolux The cleaning results are not satisfactory Limescales particles on the • The salt container is empty. dishes • The water softener is adjusted on a wrong level. • The salt container cap is not closed correctly. The dishes are wet and dull •...
19 Water connection Make sure that the drain hose is not bent or Water inlet hose squashed to prevent that the water drains Connected the appliance to a hot (max. 60°) does not drain correctly. or cold water supply.
20 electrolux Electrical connection Do not use multi-way plugs, connectors Warning! The manufacturer is not responsible if you do not follow these and extension cables. There is a risk of safety precautions. fire. Do not replace the mains cable yourself.