What To Do If - Electrolux ESF 66810 User Manual

18 electrolux
Avoid over tilting the machine during trans-
portation.

What to do if...

The appliance will not start or stops during
operation.
Certain problems can be due to the lack of
simple maintenance or oversights, which can
be solved with the help of the hints described
in the chart, without calling out an engineer.
With the appliance door closed the mal-
function is shown by the fully flashing
blue light of the programme progress
display and an intermittent audible sig-
nal is heard.
Fault codes and malfunction
• continuous flashing of the light of the running
programme
•
appears in the digital display
The dishwasher does not fill with water
• continuous flashing of the light of the running
programme
•
appears in the digital display
The dishwasher will not drain
• continuous flashing of the light of the running
programme
•
appears in the digital display
Anti-flood device is activated
Malfunction
The programme does not start
Once these checks have been carried out
switch on the appliance and close the door.
The programme will continue from the point
at which it was interrupted.
Open the door and check which fault code
the digital display shows. Switch off the ap-
pliance and carry out the suggested correc-
tive actions given in the following chart.
For fault codes not described in the chart,
please contact your local Service Force Cen-
tre.
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the water inlet hose
is blocked.
Clean the filter.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
Possible cause and solution
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
If the malfunction or fault code reappears
contact your local Service Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).