System Reset; Communication Setup; Selecting The Connection Method; Changing The Communications Settings - Pioneer BDP-330 Operating Instructions Manual

Settings

System Reset

You can reset all settings to the factory presets.
Item
Reset, Not Reset

Communication Setup

By connecting to the Internet, you can enjoy BD-LIVE
functions, YouTube videos and text information using
the RSS reader function, as well as update this player's
software. This section describes the procedure for
making network settings. You can connect to the
Internet either by using a LAN cable or by connecting
a USB Wireless LAN Adaptor to one of the USB ports.
NOTE
• Check that LAN cable or USB Wireless LAN Adaptor is
properly connected (page 20).
• BDP-LX53/BDP-330 only: When USB Wireless LAN
Adaptors are connected to both the USB ports on the
player's front and rear panels, the USB Wireless LAN
Adaptor last connected is used.
• Check the following information about the wireless LAN
access point beforehand:
− Type of encryption and encryption key
− SSID (network name)
• For manually performing the setting, the following
information of the connected router or modem is required.
Confirm the information prior to the setting.
− IP address, netmask, gateway, DNS IP address
• If specified by the provider, check the IP address and proxy
server settings beforehand.

Selecting the connection method

1
Press HOME MENU to display the HOME
MENU screen.
Press  to select "Settings", then
2
press ENTER.
3 Press  to select "Communication Setup",
then press ENTER.
Press  to select "Cable/Wireless Select",
4
then press ENTER.
5 Press  to select the connection type, then
press ENTER.
• Cable: Select this to connect to the network using a
LAN cable.
• Wireless: Select this to connect to the network using a
USB Wireless LAN Adaptor.
Changing the communications
settings
1
Press HOME MENU to display the HOME
MENU screen.
2 Press  to select "Settings", then
press ENTER.
Press  to select "Communication Setup",
3
then press ENTER.
4 Press  to select the connection method you
want to set, then press ENTER.
• Ethernet Setup(Cable): Change the settings for
connecting to the network using a LAN cable.
• Ethernet Setup(Wireless): Change the settings for
connecting to the network using a USB Wireless LAN
Adaptor.
5 Press  to select "Change", then press
ENTER.
Setting the info. of the Ethernet
[Current Setup]
IP Address : Auto Setup
Netmask
Gateway
DNS
Proxy
Change
• For initializing the current setting, select "Initialize",
then press ENTER.
• When "Ethernet Setup(Cable)" was selected at step 4,
proceed to step 10.
Press  to select the access point, then
6
press ENTER.
Press  to set the type of encryption, then
7
press ENTER.
• When "OPEN" is selected, proceed to step 9.
• When "WEP", "WPA" or "WPA2" is selected, input
the encryption key. Select "security key", then press
ENTER. For instructions on inputting characters, see
page 47.
Press  to select "Next", then press
8
ENTER.
9
Press ENTER to test the connection.
: Auto Setup
: Auto Setup
: Auto Setup
: Not Use
Initialize
45