Care And Cleaning; Light Bulbs; Metal Grease Filter - GE Monogram ZV850 Owner's Manual

For your
Before servicing or cleaning the unit, switch
power off at the service panel and lock the
safety
service panel to prevent power from being
switched on accidentally. If the service panel
cannot be locked, fasten a tag or prominent
warning label to the panel.
Metal
Clean the grease filter after 30 hours of "on" time.
A signal light will alert you when 30 hours has
grease
passed.
filter
Remove the grease filters and wash them
either by hand or in the dishwasher using
non-abrasive soap.
To clean, swish the filters in hot soapy water or
wash them in the dishwasher. Do not use abrasive
cleansers.
Hood
Do not use a steel wool pad; it will scratch
the surface.
surfaces
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always
wipe the surface in the direction of the grain.
Follow the cleaner instructions for cleaning
the stainless steel surface.

Light bulbs

To change the light bulbs:
1. Remove the trim ring by turning it
2. Grasp the bulb on the edges and pull it
3. Replace with the same size bulb.
6
counterclockwise.
straight out.
These 12 volt, 20 watt halogen bulbs are
available at specialty lighting stores. Ask for GE
bulb or equivalent: Q20MR16/C/CG40–BAB.

Care and Cleaning

Stainless Steel Hood
NOTE: To remove filters
push them back and
down using the knob.
Front
For proper operation, be sure to
use the lower set of filter holders.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:
National Parts Center
ge.com
1.800.626.2002