AEG DD 8794 Operating And Installation Manual
Hide thumbs
Also See for DD 8794:
- User manual (72 pages) ,
- Operating and installation instructions (22 pages) ,
- Operating and installation manual (22 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG DD 8794
Summary of Contents for AEG DD 8794
- Page 1 DD 8794 DD 8795 CHDD 8795 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Campana extractora Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice d’utilisation et d’installation Operating and Installation Instructions Instrucciones de montaje y manejo...
-
Page 2: Table Of Contents
Contents Safety warnings For the user For the installer Description of the Appliance Extractor version Filter Version Control Panel Switching on the hood Switching on the light Control device for grease or charcoal filter Led signal for grease filter Led signal for charcoal filter Re-setting the saturation signal Maintenance and care Cleaning the hood... -
Page 3: Safety Warnings
Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. - Page 4 • The air outlet installation must comply with the regulations laid down by the relevant authorities. • When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approxi- mately the same as the outlet hole. •...
-
Page 5: Description Of The Appliance
Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version •... -
Page 6: Control Panel
Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. -
Page 7: Switching On The Hood
depress towards the Switching on the hood - Fig. 3 bottom to switch on The control ball is a balancer switch. the hood. Depressing the control ball repeatedly towards the bottom, switches on the hood and you may select the suction level desired, depressing once again the hood switches off. -
Page 8: Maintenance And Care
Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products. •... -
Page 9: Removing The Metal Grease Filter
Removing the metal Handle grease filter Bild 3 Pull the handle downards, then extract the filter.Fig. 5. Hand washing Soak grease filters for about one hour in hot water with a grease- Fig. 5 loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. -
Page 10: Charcoal Filter
Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). •... -
Page 11: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 12: Special Accessories
Remote control RM 8700 942 120 658 Telescopic chimney (for extractor version only) 942 120 750 Inox side panels (Only DD 8794) 942 120 768 Aluminium side panels 942 120 769 * Not available in UK, please contact your local Service Force Centre. -
Page 13: Technical Specifications
Technical Specifications Dimensions (in cm): Height x Width x Depth 80 x 89,8 x 33,5 Maximum absorbed power: 235 W Motor absorption: 175 W Lighting: 3 x Typ P HILIPS TANDARD Code 425409, mit 12V 20W 30° Ø35 12V GU4 Length of the cable: 150cm Electrical connection:... -
Page 14: Electrical Connection
Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. -
Page 15: Wall Unit Mounting
Wall unit mounting - Fig. 8-9-10-11 • Place the three rubber strips on the back of the cooker hood. Where necessary mount the two spacers provided on the drill holes for definitive fixing. The spacers are useful when the wall which is to house the cooker hood is not perfectly vertical (for example: where it is partially covered with wall tiles). - Page 16 • Sign the wall with a center line, this will aid mounting procedure (1), position the template so that the mid line printed on the template matches with the center line previously signed, the lower side of the template corresponds to the lower side of the hood once mounted (2).
- Page 17 • Fix the sides of the cooker hood by fastening the pins (10a) to the sides of the fastening screws (10b). Only DD 8794: side panels are available as a special accessory please contact your local Service Force Centre (or see paragraph “Special...