Call Forwarding - All Calls Dialog Box; Call Forwarding - All Calls Access Code Dialog Box - NEC Dterm PSIII User Manual

3-38 Using the PSIII
NOTE
Figure 3-47 Call Forwarding - All Calls dialog box
Figure 3-48 Call Forwarding - All Calls Access Code dialog box
NOTE
Press the FNC key to enter.
Step 9
Press the FNC key to confirm.
Step 10
A setting tone will ring and then the PSIII returns to a standby state after
two seconds.
Call Forwarding - All Calls
This feature allows you to set the access code to establish call
forwarding on all calls.
Check with your system administrator for the list of access codes.
To Set the Call Forwarding - All Calls Access Code
Press FNC+3+5+3. A Call Forwarding - All Calls dialog box displays
Step 1
(Figure 3-47).
CFW ALL
[1]Set
[2]Reset
Press the FNC key or 1. For Mode 2* systems, a Call Forwarding - All
Step 2
Calls Access Code dialog box displays
Access No?
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
Type in the access code to establish Call Forwarding - All Calls.
Step 3
*2=Call Forwarding - All, Set.
Example:
(Figure 3-48).
Dterm PSIII User Guide - Revision 1