Problem Solver - GE Monogram ZDIW50 Use & Care Manual And Installation Instructions

PROBLEM
ICEMAKER DOES
NOT RUN
ICEMAKER RUNS BUT
PRODUCES NO ICE
ICEMAKER RUNS
BUT PRODUCES
VERY LITTLE ICE
GRID IS NOT CUTTING
ICE SHEETS
TASTE IN ICE CUBES
If you need more help...call, toll free:
®
GE Answer Center , 800.626.2000
consumer information service
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
• Cycle Control Knob must be in the "ON" position.
• Check to see that the power cord is plugged in.
• Have you checked your home's main fuses or circuit breaker box?
• Room temperature must be above 55°F. (13°C.). Otherwise, the bin thermostat
may sense the cold room temperature and shut off even though the bin is not
full of ice. Also, the icemaker may not restart once it does shut off.
• Cycle Control Knob must be in the "ON" position.
• Check water supply to make sure it is open.
• If the icemaker is operated at an elevation of 2,000 feet or more above sea level,
both the bin thermostat and ice thickness thermostat need to be recalibrated.
See the Installation Instructions.
• Room temperature may be extremely high, more that 90°F. (32°C.). In this case
it is normal for ice production to be low.
• Dirt or lint may be blocking the air flow through the finned condenser.
Condenser needs to be cleaned.
• Check to see if the icemaker has a scale build-up in water and freezing system.
Clean if necessary.
• Check the grid harness plug to make sure the connection is secure.
• There may be an unusually high mineral content in the water supply. Water may
need to be filtered or treated.
• Do not store any foods in the ice bin.
• Packaging material not all removed.
19