Burners - GE Gas Grill Use And Care Manual

Burner
Ensure the gas supply is off, the knobs are in the
OFF position and all surfaces are cool before
removal
removing a burner.
(on some models)
The grill and range-top burners are cast iron
coated with porcelain enamel. Occasionally
it will be necessary to remove surface rust to
ensure proper performance. Frequency of
cleaning will depend on the climate and
location and how often you use the cooking
center. The walls of the burners are thick so
they can withstand many years of use.
To remove the grill burner(s), remove the grill
rack(s), then lift out the stainless steel radiant
tray(s) with the lava rocks or ceramic briquettes
still on it. Remove wire shipping ties if present.
Grasp the burner, pull it up and slightly to the
rear of the unit so the burner head comes off
the brass orifice at the front. Angle the burner
sideways and remove.(24 models have two
grill burners.)
To remove the range-top burners (on some
models), remove the top grates. Lift out
aeration pan from around the burners. Lift and
remove the front and rear range-top burners.
The smoker burner (on some models) can be
removed and cleaned by unplugging the igniter
wire and lifting out the burner.
To reassemble the burners, replace the burner
by sliding the air shutters over the brass orifice,
centering it in the hole. It is extremely important
to center the burner on the orifice properly.
Be careful not to upset the air shutters' original
position (unless readjusting). Lower the rear
of the burner into the cutouts on the support
channel and make sure the locating hole in the
burner end is seated over the pin in the burner
box. Make sure all burners are level and do
not rock.
On 24 models, to double check if the two
burners are properly seated over the brass
orifices, you can visually inspect them.
1. Remove the two outer control knobs.
2. Remove the two screws underneath the
3. Rotate the control panel forward. (Do not
4. Shine a flashlight in the gap to make sure the
22
control knobs and the two screws underneath
the control panel.
remove it.)
burners are over the brass orifices. Replace
screws and knobs.
Care and Cleaning
Stainless Steel Outdoor Cooking Center
Flash tubes
Lighter
ports
Igniter
Burner hanger
Range-top burner
Grill burner for 27 36 and 48 models
Grill burners for 24 model
Replace the stainless steel radiant tray so that
the slots in the corners of the tray align with
the projections on the top of the burner. (On
24 models the stainless steel radiant trays sit
level on the side supports.) Make sure that it
sits level and does not rock.
Light all of the burners and check for proper
flame characteristics. (Do not attempt to light
the burners prior to replacing radiant trays,
grills and aeration pans.) If adjustments are
necessary refer to the Installation Instructions.
Venturi tube
Air shutters