Charging The Battery; Connecting To A Computer - Casio 2001 Getting Aquainted Manual

Charging the Battery

The watch contains a rechargeable lithium ion battery that supplies power for
normal operation.
A full charge provides approximately four
hours of continuous playback, or
approximately two months of continuous
10 58 8
35
time display.
It takes approximately four hours to achieve
a full charge.
The BATT (low battery) indicator appears
on the display of the watch when battery
power is low. MP3 file playback is disabled
Low battery indicator
while the BATT indicator is displayed. The
timekeeping function continues to operate
for about four days after the BATT indicator
appears.
The BATT indicator may also appear when
you are in a very cold area. MP3 file
playback is disabled at this time as well.
Important!
Use only the Interface/Charger Unit and AC Adaptor that comes with the
watch to charge its battery.
Proper charging may be impossible if the contacts inside the Interface/
Charger Unit tray or on the watch become dirty. Keep the contacts clean
by wiping them periodically with a dry cotton swab.
Never allow the Interface/Charger Unit or watch contacts to become
shorted.
Best results are obtained when charging is performed under room
temperature (around 23 C).
Do not subject the Interface/Charger Unit to vibration while charging is
taking place. Doing so can result in a poor connection and improper
charging.
To charge the battery
1. Remove the earphone attachment from the watch, if it is attached.
2. Connect the AC Adaptor to the Interface/Charger Unit and plug it into a
wall outlet.
3. Angle the left side (9 o'clock side) of the watch into the Interface/Charger
Unit tray so the two tabs in the tray enter the holes in the side of the
watch.
Tab
Tab
4. Lay the watch the rest of the way into the tray and then slide the tray in
the direction indicated by the arrow until it locks into place with a click.
The lamp on the Interface/Charger Unit lights red to indicate that charging
has started when the watch is correctly mounted in place. This lamp goes
out when charging is complete.
To remove the watch from the Interface/Charger Unit
1. Press the release button to release the tray.
2. Slide the tray open and remove the watch.
Note
The amount of operation you can expect on a full charge depends on
conditions when the battery is charged, the conditions of the battery,
temperature, and other factors.
The watch's rechargeable battery requires periodic replacement. If the
amount of operation provided by each full charge becomes noticeably
short, it probably means that you need to have the battery replaced.
Contact your original dealer or CASIO distributor about having the battery
replaced. Note that you will be charged for battery replacement.

Connecting to a Computer

You need to connect the watch to a computer when you want to download
MP3 files.
Note
To download MP3 files from your computer to the watch, you must also
install the software contained on the CD-ROM what comes with the watch.
See the contents of the Manual folder on the CD-ROM for more
information.
To connect the watch to a computer
1. Remove the earphone attachment from the watch, if it is attached.
2. Connect the Interface/Charger Unit to your computer using the USB cable
that comes with the watch.
Plug the ends of the USB cable securely into the proper ports, as far as
they will go. Proper operation is not possible if connections are not secure.
When using the Interface/Charger Unit to connect to a computer, there is
no need to connect the AC Adaptor to the Interface/Charger Unit.
Operation is not guaranteed when you connect to a computer that has
another USB device connected to it.
Operation is not guaranteed if you are using a USB hub or a USB cable
extension. Be sure to use only the USB cable that comes with the
Interface/Charger Unit.
Proper operation may not be possible, depending on the type of the USB
devices being used.
When connecting to a computer, make sure the temperature is as close to
room temperature (around 23 C) as possible.
3. Angle the left side (9 o'clock side) of the watch into the Interface/Charger
Unit tray so the two tabs in the tray enter the holes in the side of the
watch.
Tab
Tab
4. Lay the watch the rest of the way into the tray and then slide the tray in
the direction indicated by the arrow until it locks into place with a click.
To remove the watch from the Interface/Charger Unit
1. Press the release button to release the tray.
2. Slide the tray open and remove the watch.
2001/2002-3
USB port