Headset Information; Accessories For The Cisco Unified Wireless Ip Phone 7925G - Cisco 7925G (SCCP) User Manual

2. After completing authentication and registration with Cisco Unified Communications Manager Express, the phone displays
the main screen and is ready to place or receive calls.
Check Signal Strength
The icon indicates the strength of the signal between the wireless access point and your phone. Your phone must have at
least one bar to place or receive calls.
When you move the phone out of signal range, you lose connection with the wireless LAN. The
line displays, "Leaving service area."
Your idle phone screen can turn off after a time interval. To alert you that the phone is still powered on and connected
Tip
to the wireless network when using battery power, the indicator light blinks green every 2 seconds.

Accessories for the Cisco Unified Wireless IP Phone 7925G

The following phone accessories are available for your phone:
• Standard and extended batteries
• AC power supplies for different geographical areas
• Desktop charger with speakerphone
• Carrying cases
• Lock sets
For a complete list and description of accessories, see the

Headset Information

Although we performs some internal testing of third-party headsets for use with the Cisco Unified IP Phones, Cisco does not
certify or support products from headset or handset vendors. Because of the inherent environmental and hardware
inconsistencies in the locations where Cisco Unified IP Phones are deployed, there is not a single "best" solution that is optimal
for all environments. We recommend that customers test the headsets that work best in their environment before deploying a
large number of units in their network.
In some instances, the mechanics or electronics of various headsets can cause remote parties to hear an echo of their own voice
when they speak to Cisco Unified IP Phone users.
We recommend the use of good quality external devices, like headsets that are screened against unwanted radio frequency (RF)
and audio frequency (AF) signals. Depending on the quality of these devices and their proximity to other devices such as cell
phones and two-way radios, some audio noise may still occur.
The primary reason that a particular headset would be inappropriate for the Cisco Unified IP Phone is the potential for an
audible hum. This hum can be heard by either the remote party or by both the remote party and you, the Cisco Unified IP Phone
user. Some potential humming or buzzing sounds can be caused by a range of outside sources, for example, electric lights, being
near electric motors, and large PC monitors.
Audio Quality Subjective to the User
Beyond the physical, mechanical and technical performance, the audio portion of a headset must sound good to you (the user)
and to the party on the far end. Sound is subjective and Cisco cannot guarantee the performance of any headsets, but some of
the headsets on the sites listed below have been reported to perform well on Cisco Unified IP Phones.
Nevertheless, it is ultimately the user's responsibility to test this equipment in their own environment to determine suitable
performance.
For information about headsets for your phone, see the
websites:
http://www.plantronics.com
•
http://www.jabra.com
•
http://www.jawbone.com
•
10
Cisco Unified Wireless IP Phone 7925G Accessory Guide.
Cisco Unified Wireless IP Phone 7925G Accessory Guide
icon appears, and the status
and these