Switching The Server On And Off - Fujitsu PRIMERGY Econel 100 Operating Manual

Switching the Server ON and OFF

5.2 Switching the Server ON and OFF
V
CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see
shooting and Tips" on page
The power button does not separate the server from the line voltage. To
disconnect the device completely from the mains, you must switch off the
master switch (if present on the back of the device) (see
page 33) and remove the plug.
Switching the server ON
The power-on indicator (position 2 in
(standby mode) when the server is connected to the network and the master
switch (if present) is switched on (see
– First system installation:
Ê Press the ON/OFF button (position 3 in
Power-on indicator lights green (position 2 in
Ê Insert the ServerStart-CD and/or an installation disk in the corresponding
drive.
Ê Follow the on-screen instructions (see also
ServerStart" on page 36
on page 37).
– System already installed:
Ê Press the ON/OFF button (position 3 in
The server is switched on, performs a system test and boots the
operating system.
Switch off server (ACPI compatible operating systems, e. g.
Windows 2000, Linux)
The power-on indicator lights green (position 2 in
Ê Terminate the operating system correctly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights orange.
34
Preparation for Use and Operation
41).
figure 4 on page
figure 5 on page
figure 4 on page
or section "Configuration without ServerStart"
figure 4 on page
Operating Manual
chapter "Trouble-
figure 5 on
31) lights orange
33).
31).
figure 4 on page
section "Configuration with
31).
figure 4 on page 31).
31).
Econel 100