Setting The Jumpers On The Communication Board - Bosch NurseCall Main Unit User Manual

18 en | Installation
3.2.7

Setting the jumpers on the communication board

1.
2.
3.
Setting the jumpers for a DECT phone system, Alarm Management Software, NPS
programming or Medicall 800:
Setting the jumpers for Paging systems (except Medicall 800) and printers:
4.
F.01U.252.699 | V1.1 | 2012.01
Disassemble the unit; see Section 7.5.1 Disassembling the unit, page 48.
Remove the communication board; see Section Removing the communication board,
page 48.
Set the jumpers as required in your configuration. By default the jumpers are set for
connection to a DECT phone system.
Assemble the communication board and the unit. This is basically the reverse of the
disassembling procedure, see Section 7.5.1 Disassembling the unit, page 48.
User Manual
NurseCall Main Unit
Bosch Security Systems