Configuring The Rate Limit; Displaying And Maintaining Traffic Policing, Gts, And Rate Limit; Traffic Policing And Traffic Shaping Configuration Example; Network Requirements - HP 6125XLG Configuration Manual

Configuring the rate limit

The rate limit of a physical interface specifies the maximum rate of incoming packets or outgoing packets.
To configure the rate limit:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the rate limit
for the interface.
Displaying and maintaining traffic policing, GTS,
and rate limit
Execute display commands in any view.
Task
Display QoS and ACL resource usage.
Display traffic behavior configuration
information.
Display GTS configuration and statistics on
an interface.
Display rate limit configuration and statistics
on an interface.
For more information about the display qos-acl resource command, see ACL and QoS Command
Reference.
Traffic policing and traffic shaping configuration
example

Network requirements

As shown in
• Ten-GigabitEthernet 1/1/7 of Device A is connected to Ten-GigabitEthernet1/1/5 of Device B.
Server, Host A, and Host B can access the Internet through Device A and Device B.
•
Perform traffic control on Ten-GigabitEthernet 1/1/5 of Device A for traffic received from Server and
Host A, respectively, to meet the following requirements:
Command
system-view
interface interface-type interface-number
qos lr { inbound | outbound } cir
committed-information-rate [ cbs
committed-burst-size ]
Figure 1 1:
Command
display qos-acl resource [ slot slot-number ]
display traffic behavior user-defined [ behavior-name ]
display qos gts interface [ interface-type interface-number ]
display qos lr interface [ interface-type interface-number ]
39
Remarks
N/A
N/A
By default, rate limit is not
configured on an interface.