Engine Air Cleaner - Craftsman 1750 User Manual

A. CLEANING WATER INLET FILTER
The water inlet to the washer is protected by a filter
which should be cleaned if it is found to be dirty.
- Disconnect water inlet hose.
- Pull out internal filter.
- Clean filter.
- Reinstall filter.
B. CHECK MOTOR OIL LEVEL
Be sure oil level is maintained.
- Remove oil dipstick and wipe oil from dipstick with
clean cloth.
- Screw dipstick firmly into place until cap bottoms on
tube.
- Remove to check oil level.
Dipstick assembly must be firmly assembled into
tube when engine is operating.
C. CLEAN STATIC GUARD
- Clean the area shown to prevent overheating and
engine damage.
Caution: To assure smooth operation, keep
governor linkage, springs and controls free of debris.
12
CUSTOMER RESPONSIBILITIES
D. CLEAN ENGINE
Remove dirt and debris with a cloth or brush. Cleaning
with a forceful spray of water is not recommended as
water could contaminate the fuel system.
E. SERVICE AIR CLEANER
1. Loosen screw and tilt cover as illustrated.
2. Carefully remove cartridge.
3. Clean by tapping gently on a flat surface. If very
dirty, replace cartridge or clean as follows:
Wash in a low or non-sudsing detergent and warm
water solution. Rinse thoroughly with flowing water
from mesh side until water runs clear. Let cartridge
air dry thoroughly before using.
Caution: Petroleum solvents, such as kerosene,
are not to be used to clean cartridge. They may
cause deterioration of the cartridge. Do not oil
cartridge. Do not use pressurized air to clean or dry
cartridge.
4. Install cartridge, then close cover and fasten screw
securely.
F. CLEAN SPARK ARRESTER (OPTIONAL)
If engine is equipped with spark arrester screen
assembly, remove for cleaning and inspection.Replace
if damaged.