Cisco 2600 Datasheet page 3

Table 3 lists the supported primary and secondary video stream combinations on the Cisco Video Surveillance 2600
IP Camera.
Table 3.
Primary
H.264
H.264
MPEG4
MPEG4
Table 4 lists the supported primary and secondary video streams on the Cisco Video Surveillance 2600 IP Camera.
Table 4.
NTSC Primary
Channel Resolutions
4 CIF, CIF
PAL Primary
Channel Resolutions
4 CIF, CIF
Note: Features with an asterisk are not supported or applicable when the camera is used with Cisco Video
Surveillance Manager.
Connectors
Table 5 describes the connectors on the Cisco Video Surveillance 2600 IP Camera.
Table 5.
Item
Network connectivity
Video
*
Audio
Serial port
Alarm input
Alarm output
Power input
Note: Features with an asterisk are not supported or applicable when the camera is used with Cisco Video
Surveillance Manager.
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Supported Primary and Secondary Video Stream Combinations
Secondary
H.264
MJPEG
MPEG4
MJPEG
Cisco Video Surveillance 2600 IP Camera Video Stream Support
NTSC Primary Frame Rate
30, 25, 20, 15, 10, 8, 6, 5
PAL Primary Frame Rate
25, 20, 15, 10, 8, 6, 5
Cisco Video Surveillance 2600 IP Camera Connectors
Specification
10/100 BASE-TX Ethernet with RJ-45 connector
1 analog output BNC connector, 75 ohms
● 1, 3.5-mm output jack for optional external speaker
● 1, 3.5-mm input jack for optional external microphone
● Built-in microphone
● Two-way (full- and half-duplex), one-way, or audio off
RS-485 (2-wire), Pelco D protocol only
2, logic-level programmable
*
2, logic-level programmable
2-pin terminal
NTSC Secondary
Channel Resolutions
CIF
PAL Secondary
Channel Resolutions
CIF
Data Sheet
*
NTSC Secondary Frame Rate
15, 10, 8, 6, 5
*
PAL Secondary Frame Rate
15, 10, 8, 6, 5
Page 3 of 6