3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 91.
4. Locate the thermal sensor. See "Locating major FRUs and CRUs" on page 71.
5. Disconnect the thermal sensor cable from the thermal sensor connector on the system board. See
"Locating parts on the system board" on page 73.
6. From the inner side of the chassis, pivot the retaining clip
side to release it. Then disengage the thermal-sensor plastic holder from the chassis.
Figure 47. Removing the thermal sensor
7. Pull the entire thermal sensor out of the chassis.
1
.
Chapter 9
Replacing FRUs (machine types: 10B0, 10B1, 10B2, and 10B3)
inward and then push the clip to the outer
117