Hitachi HF-W6500 45/40 User Manual page 10

This manual describes the setup procedure of the OS installed in the HITACHI INDUSTRIAL
COMPUTER HF-W6500 Model 45/40, namely the following pre-installed OS.
・Windows® 7 Professional
・Windows Server® 2008 R2 Standard
<Organization of this manual>
This manual is organized as follows:
CHAPTER 1 SETUP PROCEDURE WHEN YOU TURN ON THE POWER FOR THE FIRST
TIME
CHAPTER 2 CONFIGURING BASIC SETTINGS AFTER OS SETUP
CHAPTER 3 RESTORING THE FACTORY-SHIPPED CONDITION USING A RECOVERY
DVD
CHPATER 4 PRECAUTION
APPENDIX A SETUP PROCEDURE WHEN USING Windows XP Mode
(FOR Windows® 7 ONLY)
APPENDIX B SETUP PROCEDURE WHEN BUILDING A VIRTUAL ENVIRONMENT
(FOR Windows Server® 2008 R2 ONLY)
<Use of terms in this manual>
In this manual, the following definition of terms is used:
・Setup: An act of configuring the environment of a computer for the purpose of using software
on the computer.
・Install: An act of incorporating software provided on a DVD, CD, or floppy disk into a hard
disk on a computer.
・Virtual machine: A virtual hardware environment provided by Virtual PC or Hyper-V
・Guest OS: An operating system that runs on a virtual machine.
・Host OS: An operating system used as a platform for running a virtual machine.
Depending on the type of failure, important files may be lost when you use this
equipment. Files can be lost by power failure and human mistakes during
operation in addition to the failure of the equipment. Should such a situation
occur, the files cannot be recovered. In order to prevent data loss, make it a
routine to save your files and establish a systematic way of backing up files.
PREFACE
NOTICE
i
™
.