Adjust
Slide up/
volume.
down VOL
+/-
Skip forward.
Press
Skip backward. Press
twice
Mute/
Press
unmute the
microphone in
a call.
Activate voice
Press
dialing
twice
Note
•
Available if supported by your mobile phone.
Other status and indicators
Headset Status
The headset is connected
to a Bluetooth device,
while the headset is in
standby mode or while
you are listening to music.
The headset is ready for
pairing.
The headset is on but not
connected to a Bluetooth
device.
There is an incoming call.
Low battery.
Battery is fully charged.
The LED is off.
8
EN
1 short beep
1 short beep
1 short beep
1 short beep
/ 2 short
beeps
2 short beeps
before dial
tone
Indicator
Blue LED flashes
every 8 seconds.
LED flashes
white and blue
alternately.
Blue LED flashes
fast.
Blue LED flashes
twice per second.
White LED
flashes.
White LED is off.
The headset is
off./Charging is
finished.
The headset beeps every
5 seconds.
Wear your headset
Adjust the headband for the best fit.
Tip
•
After use, twist both earshells, fold the headset flat for
storage.
Use with the audio cable
With the supplied audio cable, you can use the
headset with non-Bluetooth enabled devices or
use the headset on airplane. No battery power
is required when you use the headset with the
audio cable.
Caution
•
Finish your call before connecting the audio cable, as
this will switch off battery power and end an incoming
call.
Connect the supplied audio cable to
•
the headset and;
•
an external audio device.
The microphone
is muted.