Downfeed Gears; Spindle Spline; Quill & Column Surfaces - Grizzly G0751 Owner's Manual

Downfeed Gears

oil type ......Model t23963 or iso 32 equivalent
oil amount ......................................... Fill oil Cup
Lubrication Frequency ...........8 hrs. of operation
Lift the oil cup cap (see Figure 37) to fill the cup
with oil. the oil will slowly drain into the downfeed
gears over time.
oil Cup
Figure 37. downfeed gears oil cup location.

Spindle Spline

grease type ......... nLgi#2 grease or equivalent
grease amount .............................small amount
Lubrication Frequency ....................... Bi-annually
remove the drawbar cap (see Figure 38) to
expose the spindle spline.
drawbar
Cap
Figure 38. spindle spline location.
Use the coarse downfeed handles to lower the
spindle, then apply a small amount of grease
inside the resulting hole. run the spindle up and
down several times to distribute the grease.
-34-
spindle
spline
Quill & Column Surfaces
oil type ......Model t23962 or iso 68 equivalent
oil amount ............................................thin Coat
Lubrication Frequency ...........8 hrs. of operation
Use the controls to access the entire smooth
surfaces of the quill and column (see Figures
39– 40), then clean them with mineral spirits and
shop rags.
Note: Avoid removing the grease from the column
racks during cleaning.
Quill
surface
Figure 39. Quill surface location.
Figure 40. Column surface locations.
When dry, apply a thin coat of oil to the surfaces.
Move the components through the entire path of
travel to distribute the lubricant.
Model G0751 (Mfg. Since 1/13)
Column
surfaces