Advertisement
UN Test Data
1.Test Item:Impact (T6)
2.Test Purpose: This test simulates an impact.
3.Test Procedure:
The test sample cell or component cell is to be placed on a flat surface. A 15.8mm diameter bar is to be placed
across the center of the sample. A 9.1kg mass is to be dropped from a height of 61±2.5cm onto the sample.
A cylindrical or prismatic cell is to be impacted with its longitudinal axis parallel to the flat surface and perpendicular
to the longitudinal axis of the 15.8mm diameter curved surface lying across the center of the test sample. A
prismatic cell is also to be rotated 90 degrees around its longitudinal axis so that both the wide and narrow sides
will be subjected to the impact. Each sample is to be subjected to only a single impact. Separate samples are to
be used for each impact.
A coin or button cell is to be impacted with the flat surface of the sample parallel to the flat surface and the 15.8mm
diameter curved surface lying across its center.
SANYO Internal Procedure:
As above.
4.Test Requirements:
External temperature of test batteries does not exceed 170°C and there is no disassembly and no fire within six
hours of this test.
5.Test Date: 2007/10/05
6.Test Data:
Cell No.
Maximum Temperature(°C)
1
2
3
4
At first
5
cycle, 50%
charged
6
states
7
8
9
10
11
12
13
After 50
14
cycles
15
ending, in
fully
16
discharged
17
states
18
19
20
Notes: D-Disassembly, F-Fire, 0-No disassembly & no fire
(Model:3UR18650-2-T0590)
Other
event
119
0
116
0
122
0
122
0
122
0
54
0
53
0
58
0
50
0
52
0
Result
Judgement
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
P.8/10
Advertisement
