Drying Rack (Optional Purchase); Dryer Care; Cleaning The Lint Screen - Kenmore Whirpool Electric and gas dryers Use And Care Manual

DRYER CARE
The drying rack is useful for machine drying items you would not
necessarily want to tumble dry or that you would normally line dry
(for example, tennis shoes, pillows, stuffed toys).
If your model does not have a drying rack, you may purchase
one. For ordering information, please refer to the "Assistance or
Service" page of this manual, You may also contact the dealer
from whom you purchased your dryer,
To use the drying rack
1. Slide rear pegs into the dimples on the back wall of the dryer.
Lower the front legs to rest on the dryer opening,
2. Put the wet items on top of the rack. Leave space between
the items so air can reach all the surfaces. Close the door.
NOTE: Do not allow items to hang over the edge of the rack,
3. Select a timed drying cycle and temperature, or an air cycle,
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using an air cycle.
4. Push the START button,
NOTE: The rack must be removed for normal tumbling, Do not
use the automatic cycle with the drying rack.
This chart shows examples of items that can be rack-dried and
the suggested cycle, temperature setting, and drying time. Actual
drying time will depend on the amount of moisture items hold,
Rack Dry Cycle Temp Time*
Wool Sweaters Timed Low 60
Block to shape and lay flat on
the rack
Stuffed toys or pillows Timed Low 60
Cotton or polyester fiber filled
Stuffed toys or pillows Air None 90
Foam rubber filled (no heat)
Sneakers or canvas shoes Air None 90
(no heat)
*(Minutes). Reset cycle to complete drying, if needed.
Every load cleaning
The lint screen is located on the top of the dryer, Clear] it before
each load. A screen blocked by lint can increase drying time.
To clean
1. Pull the lint screen towards you. Roll lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
Some towels made of synthetic fibers and natural fibers
(polyester and cotton blends) may shed more lint than other
towels, causing your dryer's lint screen to fill up faster. Be
sure to remove lint from the lint screen before and after drying
new towels,
• If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. See "Checking Your
Vent,"
As needed
cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely
dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every six months or more
frequently if it becomes clogged due to a residue buildup.
To wash
I. Wet both sides of lint screen with hot water.
2. Wet a nylon brush with hot water and liquid detergent, Scrub
lint screen with the brush to remove residue buildup.
3. Rinse screen with hot water
4, Thoroughly dry lint screen with a clean towel. Replace
screen in dryer.
10