Motor Safety - Kenmore 116.21312 Owner's Manual

1. UnplugcordfromwalloutleLDONOT
drip water on cleaner.
2. Cleanexteriorusinga clean,softcloth
thathas beendippedin a solutionof mild
liquiddetergent a ndwater,thenwrungdry.
Wipedry aftercleaning
3, Toreducestaticelectricity anddustbuild-
up.wipe outersurfaceof cleanerand
attachments,
DO NOT USE ATTACHMENTS IFTHEY ARE
WET.
!
CAuTIoN I
Attachments used in dirty areas,
such as under a refrigerator, should
not be used on other surfaces until
they are washed. They could leave
marks.
Check motor safety filter occasionally and
change when dirty_
WARNING .......................... i
Electrical Shock Hazard
Unplug power cord from electrical
outlet, Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
andlor electrical shock.
Remove the bag as outlined in the BAG
CHANGING section,
MOTOR SAFETY FILTER
ELECTROSTATIC
This white and grey filter must be replaced
when dirty. It should be replaced regularly
depending on use conditions. The filter
CANNOT be washed as it will lose its
dust trapping ability,
I. Lift the rubber
retainer and pull
out motor safety
filter as shown.
2. Replace the fil-
ter, white side out,
by sliding it back
into place under
the ribs in the bag
cavity.. Tuck filter in
so that it fits com-
pletely under the
rubber retainer.
3_ Replace the bag as outlined in the BAG
CHANGING section.
13