Removing The Memory Module Cover; Memory Module - Dell XPS M2010 Service Manual

Back to Contents Page
Memory Module
Dell™ XPS™ M2010 Service Manual
Removing the Memory Module Cover
Removing the Memory Module
Replacing the Memory Module
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface. If you leave the area, ground yourself again when you return
to the computer.
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
NOTE: To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and
the modules must be of the same size and configuration.
The computer has two memory slots, DIMM A and DIMM B, located under the memory module cover. If you replace or upgrade the memory in your computer,
both memory modules must be the same size.
Removing the Memory Module Cover
NOTICE: To help prevent damage to the system board, you must remove the main battery before you begin working inside the computer.
1. Follow the instructions in Before Working Inside Your
2. With the computer still turned over, loosen the captive screw on the memory module cover and slide the cover toward the back of the computer to
remove it.
1 memory module cover
Removing the Memory Module
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.
1. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
2. Remove the module from the connector on the system board.
Computer, including removing the system battery.
2 captive screw