GE PDW7300N10WW Installation Instructions Manual
  1. Manuals
  2. Brands
  3. GE Manuals
  4. Dishwasher
  5. PDW7300N10WW
  6. Installation instructions manual
GE PDW7300N10WW Installation Instructions Manual

GE PDW7300N10WW Installation Instructions Manual

Built-in dishwasher
Hide thumbs Also See for PDW7300N10WW:
Table of Contents

Advertisement

Quick Links

Download this manual
Installation
Instructions
Built-In
Dishwasher
l If you have questions,call 800.GE.CARES (800.432.2737)or visit our website at: www.ge.com
I
BEFORE YOU BEGIN
Read these instructions
completely and
carefully.
IMPORTANT-
Observe all
governing codes and ordinances.
• Note to Installer-
Be sure to leave these instructions
for the consumer's and local inspector's use.
• Note to Consumer-
Keep these instructions with your
Owner's Manual for future reference.
• Skill Level - Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
See warranty information.
• Completion Time - 1 to 3 Hours. New installations
require more time than replacement installations.
IMPORTANT-
The dishwasher
MUST be installed to allow for future removal from the
enclosure if service is required.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories - See the Owner's Manual for
available custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet, gloves, safety
glasses or goggles should he worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.

Advertisement

Table of Contents
loading

Related Manuals for GE PDW7300N10WW

Summary of Contents for GE PDW7300N10WW

  • Page 1 Installation Built-In Dishwasher Instructions l If you have questions,call 800.GE.CARES (800.432.2737)or visit our website at: www.ge.com IMPORTANT- BEFORE YOU BEGIN The dishwasher MUST be installed to allow for future removal from the Read these instructions completely and enclosure if service is required.

  • Page 2: Parts Supplied

    Installation Preparation © Side and TopTrim Pieces on some models PARTS SUPPLIED: [] Two#8-18 x 5/8"Phillips special head screws, to secure dishwasher to underside of countertop Clamp Drain Hose orto side of cabinets. (Tapedto top or side of dishwasher.) [] Side and top trim pieces on some models 2 Side-mounting brackets with four #8 Pan-head mounting screws (for non-wood countertops) on #8 Phillips...
  • Page 3 Installation Preparation PREPARE DISHWASHER ENCLOSURE WARNING: To reduce the risk of electric shock, fire, or injury to persons, the installer must ensure that the dishwasher is completely enclosed at the time of installation. This WallArea • The dishwasher must be installed so that drain hose is no more than 10' in length for proper drainage.

  • Page 4: Prepare Electrical Wiring

    Installation Preparation PREPARE ELECTRICAL WIRING / _- Alternate -_ \ FOR PERSONAL SAFETY:Remove Receptacle j Location_ ", house fuse or open circuit breaker before beginning installation, Do not use an extension cord or adapter plug ._z_ __Rece_ta_l-1/2" Din.Hole(Max.) with this appliance. )Ii"...

  • Page 5: Prepare Hot Water Line

    Installation Instructions PREPARE HOT WATER LINE [STEP 11CHECK DOOR BALANCE • The line may enter from either side, rear or floor • With dishwasher on the wood skid, check the door within the shaded area shown in Figure E balance by opening and closing the door. •...

  • Page 6: Remove Toekick

    Use Power Cord Kit WX09X70910, available for • Push the small end of the drain hose over the drain purchase from an authorized GE Appliance Dealer. port of the dishwasher, see Figure L. The power cord and connections must comply with •...
  • Page 7 Installation Instructions ISTEP61 POSITION WATER LINE ISTEP 81 SLIDE DISHWASHER AND HOUSE WIRING PARTIALLY INTO CABINET DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. • Position water supply line and house wiring on the DAMAGE WILL OCCUR. floor of the opening to avoid interference with base of dishwasher and components under dishwasher.
  • Page 8 Note: The brackets are available for purchase when needed for models not factory equipped with the sidemount kit. Order part GPF65 from your authorized GE Appliance Dealer. • Fasten the left-hand bracket to the left side of the Check Level _ dishwasher frame.
  • Page 9 Installation Instructions I STEP 121 POSITION DISHWASHER, SECURE TO COUNTERTOP OR CABINET Method 2 In this step you will need the 2 Phillips special head Secure dishwasher to cabinet sides screws set aside prior to Step 1. The dishwasher must be secured to the countertop or •...

  • Page 10: Drain Line Installation

    Installation Instructions DRAIN LINE INSTALLATION ISTEP 141 CONNECT DRAIN LINE • Connect drain line to air gap, waste tee or disposer FOLLOW ALL LOCAL CODES AND ORDINANCES, using either previously determined method. Identify the type of drain hose you have. The molded end of the drain hose will fit 5/8"...

  • Page 11: Step 161Pre-Test Check List

    Installation Instructions ISTEP151 CONNECT POWER [STEP 161PRE-TEST CHECK LIST SUPPLY Review this list after installing your dishwasher to avoid charges for a service call that is not covered Skip this step if dishwasher is equipped with power by your warranty. cord.
  • Page 12 Installation Instructions ISTEP 171 DISHWASHER WET TEST [STEP 181 REPLACE TOEKICK [] Turn on power supply (or plug power cord into • Place toekick against the legs of the dishwasher, outlet, if equipped), [] Latch door. [] Push "Rinse Only" button. [] Push start/reset pad once.

Table of Contents