Table of Contents
Advertisement
51
Move refrigerator close to
final position. Remove
n
cardboard or plywood from
under refrigerator. Plug electrical
cord into the grounded outlet. Use
the screw from the parts package to
install the plug retainer. Move the
refrigerator evenly and straight into
the opening. Check that the water
line will not be kinked. Check that
slack in the electrical cord hangs
freely behind refrigerator or is placed
on top of refrigerator next to cover.
m El
.
Check that the power
switch at the too of the
cabinet is in the "OFF" pbsition.
17
%
Remove tape from rear
. leveling rods. Turn the two
leveling rods clockwise using a 516"
(8 mm) socket and ratchet until the
cabinet weight is supported by the
rear legs. Use l-318" (35 mm) open
end wrench to lower the front leveling
legs until the weight of the cabinet is
supported by legs.
Connect the fitting to the refrige,rator
water valve. Do Not over-tighten. (If
necessary, the water valve can be
removed from the underside of the
cabinet to attach the fitting. You
may have to remove the wiring
channel to get to the valve. Remove
the screw between the coils of the
water valve. Remove the
disconnected water valve and attach
the fitting. Replace the water valve.)
Slide compression nut and sleeve on
tubing with fitting for water valve.
Connect the union from the water
supply line to the compression nut
on the tubing from the water valve.
Tighten with an adjustable wrench.
Do Not overtighten.
Turn the water supply valve to the
open position. Turn the refrfgerator
switch to the "ON" position. Check
all connections for leaks.
Page 9
18
Open both doors. Place a
n
level against the underside
of the door trim at the top of
the refrigerator. Adjust the front
leveling legs until level and to the
right height for the recessed area.
Place the level on the crisper guide
in the refrigerator section to check
for levelness front to back. Turn the
right, rear leveling rod until level and
to the required height. Place the
level on the freezer basket guide to
level the left side of the cabinet.
L
side/
trim
19
n
If side panels are not used,
go to Step 10. Read Side
panel requirements, page 5, before
attaching side panels to refrigerator.
/
Remove all tape and
door bracina from
refrfgerator door. Remove the six
screws that attach the handle to the
door frame. Slide the refrfgerator
door panel into door frame. If the
panel is less than l/4" (6 mm) thick,
a filler panel will need to be installed
between the door and decorative
panel. If the decorative panel is
more than l/4" (6 mm) thick, it will
have to be routed to have a l/4"
(6 mm) edge on all sides. See
Custom panel and insert dimensions
for exact sizes to cut custom panels.
Advertisement
Table of Contents
