Kenmore 630.13952 Manual page 35

Repair
3. Note connections, remove NTC cover and disconnect wires from heater,
flow switch, NTC & Hi-Limit.
4. Push NTC latches and lift NTC from heater.
5. To remove flow switch, carefully pry housing away from switch (until tabs
clear switch), then snap switch out. Note flow switch can be removed
from right side without flipping dishwasher upside-down.
TIP: If needed, use rinse-aid to lubricate gaskets to make it easier to
assemble heater to sump and pump.
Softer bearing heaters
All heaters are "softer bearing" and have a gasket assembled to it (to connect to
the circulation pump) and use a hose clamp (172272 provided separately).
702_58300000149896_ara_en_b