Security Erase Unit (F4H); Table 96 Security Erase Unit Command (F4H); Table 97 Erase Unit Information - Hitachi Travelstar 5K320 HTS543232L9A300 Manual

14.29

Security Erase Unit (F4h)

Command Block Output Registers
Register
Data
Feature
Sector Count
LBA Low
LBA Mid
LBA High
Device
Command
Error Register
7 6 5 4
CRC UNC 0 IDN
0 0 0 V

Table 96 Security Erase Unit Command (F4h)

The Security Erase Unit command initializes all user data sectors, then disables the device lock
function.
Note that the Security Erase Unit command initializes from LBA 0 to Native Max LBA. Host Max
LBA set by Initialize Drive Parameter or Set Max Address command is ignored. So the protected
area by Set Max Address command is also initialized.
This command requests to transfer a single sector data from the host including information specified
in the following table.
If the password does not match then the device rejects the command with an Aborted error.
Word Description
00 Control word
bit 0
bit 1
bit 2-15
01-16 Password
17-255 Reserved

Table 97 Erase Unit Information

Identifier Zero indicates that the device should check the supplied password against the user password
stored internally. One indicates that the device should check the given password against the
master password stored internally.
The Security Erase Unit command erases all user data and disables the security mode feature (device lock function).
So after completing this command, all user data will be initialized to zero with write operation. At this time, it is not
verified with read operation whether the sector of data is initialized correctly. Also, the defective sector information
and the reassigned sector information for the device are not updated. The security erase prepare command should be
completed immediately prior to the Security Erase Unit command. If the device receives a Security Erase Unit
command without a prior Security Erase Prepare command the device aborts the security erase unit command.
7 6 5 4 3 2 1 0
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
1 1 1 1 0 1 0 0
3 2 1 0
0 ABT T0N AM
N
0 V 0 0
Identifier (1-Mater, 0-User)
Erase mode (1-Enhanced Erase, 0-Normal Erase)
Reserved
(32 bytes)
Command Block Input Registers
Register
Data
Error
Sector Count
LBA Low
LBA Mid
LBA High
Device
Status
7 6 5
BSY RDY DF
0 V 0
129
5K320 SATA OEM Specification
7 6 5 4 3 2 1 0
- - - - - - - -
...See Below...
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
...See Below...
Status Register
4 3 2
DSC DRQ COR IDX ERR
V - 0
1 0
0 V