Honeywell FBII OMNI 600 User Manual page 20

Miscellaneous Commands (cont)
DISPLAY ZONE DIRECTORY (LCD KEYPADS ONLY)
To view a list of the zones in the current partition, press
zones will automatically scroll.
USER LOG VIEW (LCD KEYPADS ONLY)
To view the system log, press:
(*The user code is not required if so programmed by installer.)
When the command is accepted, the display will show the most recent event.
Pressing either
Pressing any other key advances to the next valid log entry.
KEY FOB LOW-BATTERY TEST (OMNI624 and OMNI848 ONLY)
To activate the key fob low-battery test:
#
Press :
The test mode is indicated as follows:
LCD Keypad:
Keyfob Bat. Test
#56
When a keyfob button is pressed, the system will provide a display indicating if the
keyfob has a low-battery condition.
The system exits this mode when the star
KEYPAD BACKLIGHT TIMER
If you are using an OMNI-KP, OMNI-KP-US, OMNI-LCD, or OMNI-LCD-US
keypad, these keypads have a timer controlled keypad backlight that is on for 120-
seconds following a key press (timer on) or constantly on (timer off).
To change the backlight timer:
OMNI-KP or OMNI-KP-US: Press the
at the same time and hold down for two seconds until you hear a beep. Pressing the
1
key toggles a zero or one in the display.
0 = Timer off (backlight always on)
1 = Timer on (backlight on for 120-seconds following key press)
Press the
- 20 -
#
/
STAY
5
then +
Fixed-Word Keypad:
✱=Exit
FO
6
key to exit this Backlight menu.
5
+ , +
6
or exits this mode.
6
LED Keypad:
AC An acknowledgement tone is
TEST sounded.
6
key is pressed.
/
INSTANT
# 4
+
3
+ user code.*
and /
CODE
. The
keys