Honeywell NetAXS-123 Installation Manual page 22

Installing the NetAXS-123 Panels
Installation
6. Connect the Ethernet cable and the Tamper wire, as shown below.
7. Set DIP switch settings for the panel address, communication termination and biasing. See
8. Check all wiring at this time.
of warranty.
9. Apply power to the panel.
10.Check for the Run LED for a successful power-up. If the LED is blinking green, the panel is
11.Close the cover.
14 www.honeywell.com
Switch Settings, page 36.
Improper wiring can cause damage to the NetAXS-123 at power up and result in a loss
Caution:
powered up successfully.
DIP