Advertisement
Available languages
Available languages
2. tf connectingto a 4-wire supply
cable (also
mobile
homes):
The white neutral wire from the
power supply cable must not be connected to the
junction box.
Connect the green (or bare copper) wire from tile
appliance cable and the supply cable (green or bare)
wire to the ground screw inside the junction box (see
Figure 5). Cap the white neutral wire from the power
supply cable. Connect the remaining wires inside the
junction box from the power supply cable to the
matching colors of tile appliance cable wires.
Ground Wire
Red --_.
Wires
Cable from Power Supply
White Wire
Wires
Ground
(Bare or
Green Wire)
Cable from appliance
Box
U.L.-Listed
Conduit
Connector
Figure 5
4-WIRE GROUNDED JUNCTION BOX
DO NOT ground
to a gas supply pipe.
DO NOT connect
to electrical
power
supply until
appliance
is permanently
grounded.
Connect the
ground
wire before
turning
on the power.
Cooktop
Installation
1. Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 6).
Screws
Figure
6
2. Set tile cooktop
into tile countertop
cutout.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
Do not
remove
the
nylon
spacers
on
the edges
of the cooktop.
These spacers
center
the
cooktop
in the space
provided.
The cooktop
must
be centered
to prevent
excess
heat
buildup
that
may
result
in heat
damage
or fire
(see Figure
7).
6 Nylon spacers
Position brackets
/
on unit cutout
/
centerline
"<¢s:>"
_
"'"""
.-
sJ
2 P, e tainer
_
/.....
......
brackets
...........
Figure 7
Advertisement
