GE Advantium PSB1200 Installation Instructions Manual page 17

ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN
REMOVE PACKAGING AND PARTS
• Remove the drawer from the carton.
• Remove all packing material and tape.
Open the drawer and remove anLl parts inside.
Locate parts.
Assemblg
Instructions
Side Supports (2)
AssemblyInstructions
Under-the-C0unter (UTC)
MountingBracket
Screws C010r-Matched
(6 required, Screws
2 extra) (4 required,
1 extra)
i-_ UNDER-THE-COUNTER {UTC)
MOUNTING BRACKET INSTALLATION
NOTE: For UTC models PSB1200, PSB1201 and
ZSC1201 onlLl.
Open the accessorg drawer so gou have
access to the top bracket.
Remove the three screws securing the top
bracket.
rc1 Install the new UTC mounting bracket using
the screws removed previouslLl.
rD1 Close the drawer and proceed with the
installation.
[]
ASSEMBLING THE OVEN TO DRAWER
Place storage drawer on a surface with
the front of drawer hanging over the edge
of the surface. Not placing the front edge
of drawer over the edge of the surface mall
result in damage to the drawer since the front
edge of drawer hangs below the bottom
of drawer.
Place the oven on top of the storage drawer.
Make sure that the back and sides of the oven
align with the back and sides of drawer.
NOTE: The bottom of the oven side flanges will
sit directlll in front of the top of the storage
drawer side flanges.
17