Add A Passcode (Cmd 56); Bosch Security Systems | 9/04 | 46841E - Bosch D623 Series User Manual

D623 Series/D625 Series | User's Guide | Add a Passcode (Cmd 56)
4. Press [2] to change passcode authority levels. The
keypad display scrolls:
To change level
for code 3,
Press 3*.
To change level
for code 4,
Press 4*.
Push Cmd to exit
5. Enter the passcode number (1 to 32) that you want
to change the authority level for, followed by [*]
(for example, press [3] [*] to change the authority
level for Passcode 3). The keypad display scrolls
the following:
Code 3 level 2
Enter new level.
Level choices
are 1 to 4.
Push Cmd to exit
If the user does not exist in the system,
the keypad emits an error tone.
6. Enter the new authority level (1 to 4) for the
passcode that you want to change. The authority
levels are determined by the installing company.
7. Press [CMD] to exit this feature. Press [CMD]
again to return to the normal display.
18

Add a Passcode (Cmd 56)

I can perform this command.
I cannot perform this command.
Use this command to add new passcodes to the system.
This command requires the appropriate authority level
to add passcodes. To add a new passcode to the
system, you must assign an area(s) to the new user in
addition to using the other Cmd 56 features (changing
a passcode and changing a passcode authority level) as
outlined below. Only use this feature under the
direction of your security company.
1. Ensure that the system is turned off (On indicator
is off).
2. Press [CMD] [5] [6]. The keypad may prompt you
to enter a valid passcode.
3. Enter your passcode. The keypad scrolls through
the following selections:
Push 1 to change
codes.
Push 2 to change
authority level.
Push 3 to change
areas assigned.
4. Press [3] to assign an area(s) to the new user.
5. Enter the user number you wish to assign area(s) to
followed by the [*] key. For example, for User 4,
press [4] [*]). The keypad toggles between the
following displays:
Code 4 Areas:
----
Press 1 to 4 to
toggle areas.
6. Enter the area(s) you want to assign to the new
user by pressing the appropriate numeric key(s).
For example, if the user is to be assigned to Areas
1 and 2, press the [1] and [2] keys. The keypad
displays:
Code 4 Areas:
12--
To remove a currently assigned area(s), press the
corresponding numeric key(s). For example, if
User 4 is assigned to Areas 1 and 2, but should
only be assigned to Area 1, press [2] to remove
Area 2 from User 4's area assignment.
7. Press [CMD] twice to return to the three Cmd 56
selections. Then, press [1] to create a passcode for
the new user.
8. Enter the user number followed by [*]. For
example, press [4] [*] to create the passcode for
User 4.

Bosch Security Systems | 9/04 | 46841E