K e y b o a r d C a b l e
keyboard cable
Disconnect the keyboard cable and lay the keyboard assembly aside.
7
Replacing the Keyboard Assembly
While bracing the keyboard assembly upright on its left end, connect
1
the keyboard cable to the interface connector on the system board.
NOTICE: Position the keyboard/track stick flex cable so it is not pinched
when you replace the keyboard in the bottom case assembly.
Insert the metal tabs at the left end of the keyboard under the edge of
2
the bottom case assembly, and fit the keyboard into place.
Check that the keyboard is correctly installed. The keys should be flush
3
with the left and right surfaces of the palmrest.
Reinstall the four screws in the holes labeled "circle K."
4
Re m ov i n g a nd Re p l ac i n g Pa rt s
25