support.dell.com
To remove the RJ-11 card (see Figure 32), perform the following these steps:
1.
Remove the 4-mm screw securing the RJ-11 card to the system board.
2.
Lift the card off the system board.
System Board Removal
Figure 34. System Board Components
1
4-mm screws (3)
2
System board
This procedure assumes that you have removed the PC Card heat sink and hinge sad-
dles. To remove the system board (see Figure 33), perform the following steps:
1.
Remove the three 4-mm screws from the bottom of the computer.
2.
Remove the system board from the bottom case.
Removing and Replacing Parts
43