Contents Of The Setup Mode - Fujitsu fi-4750L Operator's Manual

Contents of the Setup Mode

This section describes the contents of the setup mode.
No. Item
1 Double feed check
Length check
2
=No/10/15/20 mm
3 IPC pre-setting
Resetting of
4
abrasion counter
Pick start time
5
setting
6 Time-out limit setting
ADF front offset
7
setting*
ADF back offset
8
setting*
Flatbed offset
9
setting*
7-2
Description
Specifies the double feed detection. Double
feed is detected by checking the document
length and/or paper thickness.**
Specifies the document length to enable
double feed detection sets the document
length.
Scanner automatically sets the
recommended reading parameters. 3 sets
of parameters are available when IPC-4D is
not installed.
Resets the abrasion counter.
Specifies the time from document Insertion
to the start of picking. User can select the
most comfortable Pick start time for the job.
Specifies the time the scanner waits for the
next document insertion after the last
document was scanned.
Specifies the horizontal and vertical offset
of the front side image when using the ADF.
Specifies the horizontal and vertical offset
of the back side image when using the
ADF.
Horizontal and vertical offset of the FB
image is specified.
Selectable
Default
parameters
No
Tolerance:
No
No/10/15/20mm
Document:
No
Sharpen Darken No
Charactor Copy
Quality
- -
Time:
1.0 sec
0.2 to 29.8 sec
Time:
27 values from 30 sec
1 to 1999 sec
Offset: Offset:
H:-2 to +3 mm H: 0 mm
V:-2 to +3 mm V: 0 mm
Offset: Offset:
H:-2 to +3 mm H: 0 mm
V:-2 to +3 mm V: 0 mm
Offset: Offset:
H:-2 to +3 mm H: 0 mm
V:-2 to +3 mm V: 0 mm