Configuration Wizard; Initial Setup; Assigning Hot Spares - Fujitsu ETERNUS DX60 Setup Manual

Startup
S T E P
Connect the PC to the ETERNUS DX60/DX80 with a LAN cable (for operation management), and turn on the ETERNUS DX60/
DX80.
"7.1 Setup Preparation" in the "User Guide"
n
"7.2 Basic Setup" in the "User Guide"
n
IMPORTANT
Basic Setup
S T E P
Basic ETERNUS DX60/DX80 setup is performed by accessing
the "Initial Setup" and "Configuration Wizard" functions with a
Web browser.
1. Start the Web browser on the PC and enter either of the
following URLs in the address bar of the Web browser.
http://192.168.1.1/
https://192.168.1.1/
2. Enter the following user name and password, and click the
[Logon] button to logon to the ETERNUS DX60/DX80.
User name: root
Password: root (Default)
3. After logging on, the Storage System Status screen
appears.
Point

Initial Setup

Set the necessary environment for operating the ETERNUS
DX60/DX80 with its initial setup.
The [Initial Setup] screen appears by clicking the [Initial
Setup] menu on the [Easy Setup] tab.
This screen is used to set the following items:
Set Date and Time
n
Set Storage System Name
n
Change Password
n
Set SAS Port Parameters
n
Setup Network Environment
n
The first time the power is turned on, volume
formatting may start according to the factory
default settings. This does not affect the setup
operation, which may be started immediately.
When ETERNUS SF Express is used, perform
the following setup, and then refer to the
"ETERNUS SF Express User's Guide" to install
the ETERNUS DX Disk storage system.
Initial Setup
● Set Date and Time
Set Storage System Name
●
● Change Password
Setup Network Environment
●
Power switch
After completing these settings with the Finish step, close
the web browser to end the setup session, then detach the
direct connection LAN cable (for operation management)
from the PC and connect it to the normal network. Then
try logging on again via the normal network, using the IP
address that has just been set.
"7.2.1 Initial Setup" in the "User Guide"

Configuration Wizard

Perform the necessary settings to operate the ETERNUS
DX60/DX80 using the Configuration Wizard.
The [Configuration Wizard] screen appears by clicking the
[Configuration Wizard] button on the [Easy Setup] tab.
Create RAID Group
n
Create Volume
n
Define Host
n
"7.2.2 Configuration Wizard" in the "User Guide"
Point
Default R AID groups, volumes and af finity
groups are preset in the factory. Refer to "Web
GUI User Guide" if the preset values are to be
changed.

Assigning Hot Spares

Register hot spares for use in case the regular disks fail.
The [Assign Hot Spare] screen appears by clicking [Assign
Hot Spare] under the [RAID Group Management] menu on the
[Volume Settings] tab.
"7.2.3 Hot Spare Registration" in the "User Guide"
Point
Check the factory settings and register a hot
spare as required.
Controller
Enclosure
Configure Affinity Group
n
Define LUN Mapping
n