Installing The Switch Into A Rack - D-Link DXS-3600-EM-8XS Hardware Installation Manual

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
Make sure that there is proper heat dissipation from and adequate ventilation around the switch. Leave at least 10 cm
(4 inches) of space at the front and rear of the switch for ventilation.

Installing the Switch into a Rack

This section is used to guide the user through installing the switch into a switch rack. The switch can be mounted in a
standard 19"(1U) rack using the provided mounting brackets. Use the following diagram as a guide.
How to install the mounting brackets onto the switch (Figure above) and onto the rack (Figure below):
1. Fasten the mounting brackets A and B to the sides of the switch using the screws provided, as seen in the figure
above.
2. Fasten the mounting bracket C in the appropriate open space in the rack using the screws provided, as seen in the
figure below.
3. Simply slide the switch (fastened bracket B into fastened bracket C) into the rack.
4. Lastly, fasten mounting bracket A to the rack using the screws provided.
Figure 2-2 Fasten mounting brackets on the Switch
Figure 2-3 Installing the Switch in a rack
8
A
C
B