iscsi target port
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
show iscsi
Syntax
Command Mode
Command
History
326
|
iSCSI Optimization
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication will
be monitored.
iscsi target port tcp-port-1[tcp-port-2...tcp-port-16][address ip-address]
To remove the configured iSCSI target ports or IP addresses, use the
tcp-port-2...tcp-
Enter the tcp-port number of the iSCSI target ports.
port-16
tcp-port-n
The
iSCSI target listens to requests. Separate port numbers with a comma.
Default: 860, 3260.
ip-address
(OPTIONAL) Enter the ip-address that the iSCSI will monitor.
The ip-address specifies the IP address of the iSCSI target.
860, 3260.
CONFIGURATION
Version 8.3.16.1
Introduced on MXL 10/40GbE Switch IO Module
You can configure up to 16 target TCP ports on the switch in one command or multiple commands.
no iscsi target port
When you use the
address, the IP address value must be included in the command.
Display the currently configured iSCSI settings.
show iscsi
EXEC
EXEC Privilege
Version 8.3.16.1
Introduced on MXL 10/40GbE Switch IO Module
is the TCP port number or a list of TCP port numbers on which the
command, and the TCP port to be deleted is one bound to a specific IP
no iscsi target port
command.