Using external equipment
Connecting a decoder
You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.
NOTE
• In cases when the decoder needs to receive signal from the System, make sure to set "Decoder" to "INPUT1" in the
Programme Setup "Manual" menu. (See page 28.)
AVC System (rear view)
Connecting a VCR
You can use the INPUT 2 terminal when connecting a VCR and other audiovisual equipment.
If your VCR supports TV-VCR advanced "AV Link" systems (see page 65), you can connect the VCR to the
INPUT 2 terminal on the AVC System using the fully-wired SCART cable.
NOTE
• TV-VCR advanced "AV Link" systems may not compatible with some external sources.
• It is recommended to connect to the INPUT 2 terminal when using a decoder for ground wave signal input with a VCR. If
INPUT 2 signals preset in auto installation or programme setup, make sure to set "Decoder" to "INPUT2" in the Programme
Setup "Manual" menu. (See page 28.)
AVC System (rear view)
SCART cable
(commercially available)
64
To watch an image from this input terminal, you
need to select the input source (see page 63)
and the input signal type (see page 70).
SCART cable
(commercially available)
To watch an image from this input terminal, you
need to select the input source (see page 63)
and the input signal type (see page 70).
SCART cable (commercially available)
Decoder
VCR
Decoder