Peripheral Configuration - NEC Express5800/120Rj-2 User Manual

Peripheral Configuration

IMPORTANT:
overlapped with others. If the value set for the interrupt or base I/O
address is used in another resource, the yellow asterisk (*) appears.
Reset any item with the yellow asterisk properly.
Option
Serial Port A
Base I/O address
Interrupt
Serial Port B
Base I/O address
Interrupt
USB Controller
USB 2.0 Controller
Parallel ATA
Serial ATA
SATA Controller
Mode Option
SATA AHCI
Note that the interrupt and/or base I/O address are not
Parameter Description
Disabled Selects whether serial port A is
[Enabled] enabled or disabled.
[3F8] Selects the base I/O address for serial
2F8 port A.
3E8
2E8
IRQ 3 Selects the interrupt for a serial port A.
[IRQ 4]
Disabled Selects whether serial port B is
[Enabled] enabled or disabled (display only).
3F8 Selects the base I/O address for serial
[2F8] port A.
3E8
2E8
[IRQ 3] Selects the interrupt for a serial port A.
IRQ 4
[Enabled] Selects the USB controller is enabled
Disabled or disabled.
Disabled Selects the USB 2.0 controller is
[Enabled] enabled or disabled.
Disabled Selects parallel ATA is enabled or
[Enabled] disabled.
Disabled
Not supported in this system.
[Enabled]
Leave factory setting as is.
Compatible
[Enhanced]
Disabled
[Enabled]
Configuring Your Server 4-11
Your Setting
[ ]: Factory-set