Upgrading The Software; Setting Up Your Pc Software (Based On Windows Xp) - Samsung PS-50P91FH Owner's Instructions Manual

Upgrading the Software

Samsung may offer upgrades for TV's firmware in the
future. Please contact the Samsung call center to receive
information about downloading upgrades and using a
USB drive. Upgrades will be possible by connecting a
USB drive to the USB port located on located on the side
of your TV.
1 Insert a USB drive containing the firmware upgrade into
the USB Upgrade Port on the side of the TV.
2 Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Setup, then press the
ENTER/OK button.
3 Press the ▲ or ▼ button to select SW Upgrade, then press
the ENTER/OK button.
4 Press the ENTER/OK button.
The message Scanning for USB... It may take up to 30
seconds. is displayed. Please be careful to not disconnect
the power or remove the USB drive while upgrades are being
applied. The TV will shut off and turn on automatically after
completing the firmware upgrade. Please check the firmware
version after the upgrades are complete.

Setting up Your PC Software (Based on Windows XP)

The Windows display-settings for a typical computer are shown below. But the actual screens
on your PC will probably be different, depending upon your particular version of Windows and
your particular video card. But even if your actual screens look different, the same, basic set-up
information will apply in almost all cases. (If not, contact your computer manufacturer or Samsung
Dealer.)
1 Right click the mouse on the Windows Desktop, then click on
Properties.
The Display Properties will be displayed.
2 Click on Settings tab, then set the Display Mode with
reference to the Display Modes Table. You do not need to
change the Colours settings.
3 Click on Advanced. A new settings dialog box will be
displayed.
4 Click on the Monitor tab, then set the Screen refresh rate
with reference to the Display Modes Table. Set the Vertical
Frequency and Horizontal Frequency individually if you can do
so instead of setting the Screen refresh rate.
5 Click on OK to close the window, then Click on OK button to
the Display Properties window. Automatic re-booting may commence at this moment.
English - 29
TV Side Panel TV Side Panel
T V Setup
 More
Wall-Mount Adjustment
Energy Saving : Off
HDMI Black Level : Low
PIP
Screen Burn Protection
SW Upgrade
Move Enter
T V SW Upgrade
USB
Enter
Plug & Play
Scanning for USB...
It may take up to 30 seconds.






Return

Return