AEG SANTO C 7 18 41 i Operating And Installation Instructions
AEG SANTO C 7 18 41 i Operating And Installation Instructions

AEG SANTO C 7 18 41 i Operating And Installation Instructions

Integrating fridge freezer

Advertisement

SANTO C 7 18 41 i
Integrating Fridge Freezer
Operating and Installation Instructions

Advertisement

Table of Contents
loading

Summary of Contents for AEG SANTO C 7 18 41 i

  • Page 1 SANTO C 7 18 41 i Integrating Fridge Freezer Operating and Installation Instructions...
  • Page 2 In the event of a malfunction, these operating instructions contain infor- mation on how to rectify faults yourself, see the “Something Not Working” section. For futher assistance contact your local AEG Service Force Centre, see the chapter “Service and Spare Parts”. Printed on paper manufactured with environmentally sound processes.
  • Page 3: Table Of Contents

    Contents Safety ............4 Disposal .
  • Page 4: Safety

    Safety Please read this instruction book before using the appliance and retain for future reference. These warnings are provided in the interests of your safe- ty, ensure you understand them fully before using the appliance. Intended use • The appliance is intended for use in the home. It is suitable for the coo- ling, freezing and storing of frozen food, as well as for making ice.
  • Page 5: Disposal

    Service • Under no circumstances should you attempt to repair the appliance your- self. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local AEG Service Force Centre. Disposal Appliance Packaging Information All materials are environmentally sound.
  • Page 6: Remove Transport Packaging

    Disposal of old Appliances For environmental reasons, refrigeration appliances must be disposed of properly. This applies to your old appliance, and - at the end of its service life - to your new appliance as well. Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures, to prevent small children being trapped inside.
  • Page 7: Starting Up And Temperature Regulation

    Starting up and temperature regulation Wash the inside of the appliance with lukewarm water with a little bicar- bonate of soda added (5ml to 0,5 litre of water). Do not use soap or deter- gent as the smell may linger. Dry the appliance thoroughly. •...
  • Page 8: Interior Accessories

    Interior Accessories Storage Shelves The glass shelf above the fruit and vegetable compartment should always remain in position, to ensure fruit and vegetables stay fresh longer. The remaining storage shelves can be adjusted to various heights: Pull the storage shelf forward until it can be tipped up or down and remo- ved.
  • Page 9: Freezing And Storing Frozen Food

    wrapped in aluminium foil or polythene bags to exclude as much air as pos- sible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not in airtight containers, must not be kept in the refrigerator.
  • Page 10: Ice Pack

    Place the packed food in the drawers. Place food to be frozen in the upper drawer. Unfrozen food must not touch items already frozen, otherwise the frozen food could begin to defrost. When freezing fresh food, depress the ambient temperature switch (A) 12 hours before loading the food without modifying the thermostat setting.
  • Page 11: Storage Goods Symbols/Freezing Calendar

    Storage Goods Symbols/Freezing Calendar • The symbols on the drawers show different types of frozen goods. • The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated sto- rage time is valid depends on the quality of the foods and pre-treating before freezing.
  • Page 12: Switching Off The Appliance

    Insert the plastic scraper into the recess provided under the defrost water channel and place a collecting basin under it. Once defrosting is completed keep the scraper handy for future use; Turn the thermostat knob to the required setting or replace the plug in the power socket.
  • Page 13: Energy Saving Tips

    • The appliance must be dry before it is placed back into service. Warning! • Ethereal oils and organic solvents can attack plastic parts, e.g. – lemon juice or the juice from orange peel, – butyric acid; – cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts.
  • Page 14: Something Not Working

    Something Not Working If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre. Warning! Repairs should only be carried out by qualified service engineers. Repairs carried out by inexperienced persons may cause injury or serious malfunc- tioning.
  • Page 15: Changing The Light Bulb

    If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre. In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.
  • Page 16: Service And Spare Parts

    Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. Customer Care Department For general enquiries concerning your AEG appliance or for futher information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.aeg.co.uk.
  • Page 17: Guarantee Conditions

    GUARANTEE CONDITIONS Standard guarantee conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG applian- ce or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ·...
  • Page 18: Installation

    Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
  • Page 19: Positioning

    Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rat- ing plate, which is located on the inside left of the appliance. The following table shows which ambient temperature is correct for each climate classification.
  • Page 20: Housing Dimensions

    Unscrew the upper pin and remo- ve the spacer Remove the upper door Unscrew the middle hinge and the brackets and refit them on the opposite side Refit the upper door, the upper pin and the spacer on the oppo- site side Unscrew the lower pin and remo- ve the spacer and refit them on...
  • Page 21: Instructions For Total Building-In

    Instructions for building-in Apply joint the sealing strip as shown in figure. D765 Push appliance into the housing until stop strip (A) touches the kitchen unit. Open the door and push the appliance against the side of the kitchen unit op- posite to that of appliance hinges.
  • Page 22 Apply covers (B) into the relevant holes. Separate parts A, B, C, D as shown in the figure Place guide (A) on the inside part of the furniture door, in the upper and lower positions as shown in the fig- ure and mark the position of external holes.
  • Page 23 Fix cover (C) on guide (A) until it clips into place. Open the appliance door and the fur- niture door at 90°. Insert the small square (B) into guide (A). Put togeth- er the appliance door and the furni- ture door and mark the holes as indi- cated in the figure.
  • Page 24: Regulations, Standards, Guidelines

    Fix cover (D) on guide (B) until it clips into place. If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in the fixing brackets (D), move the brackets as shown in the figure and re-tighten the screws. Then fit cover (E).
  • Page 28 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de 2222 020-58 © Electrolux plc 2003...

This manual is also suitable for:

Santo c 7 18 41-4i

Table of Contents