Table of Contents
Advertisement
Overview
This document contains step-by-steps disassembly instructions for VERSA E3100 notebook. The instructions
explained how to remove or disassemble a particular part with the help of photos. The size of the screws in used is
display on the right side of the guide.
NEC reserves the right to make any changes to this disassembly guide without notice.
Technician Notes
Only technician/engineer authorized by NEC Computer Asia Pacific should attempt to repair this equipment. All
troubleshooting and repair procedures are display to allow subassembly/module level repair. Because of the
complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component
level or to make modifications to any printed wiring board. Improper repairs can create a safety hazard. Any
indication of component replacement or printed wiring board modifications may void any warranty or exchange
allowances.
Disassembly Instructions
When disassembling the system, follow these general rules:
Do not disassemble the system into part smaller than illustrated by this manual.
Label all removed connectors. Note where the connector goes and what position it originally installed.
Disconnect the system from the power adaptor.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Correct size and type of screw need to reinstall back. Check
that no tools or any loose parts left inside the chassis. Check that everything properly installed and all screw
tightened.
Required Tools
All disassembly procedures can be perform using the following tools:
PH 0x60 Philips screwdriver
PH 0x40 Philips screwdriver
SW5.0 Spacer screwdriver
Flat screwdriver
Small tweezers
Pin
NEC VERSA E3100 Disassembly Manual
Page 3
Hide quick links:
Advertisement
Table of Contents
