This information also appears on the warranty registration card. Please complete and mail your For nearly five decades and three generations, U-Line continues to warranty registration card. You may also register online at be the leader in innovation, quality and value in the premium www.u-line.com...
Normal Operating Sounds ..........................16 Troubleshooting Guide ............................. 16 Before Calling for Service ..........................16 If Service is Required ............................16 Replacement Parts ............................. 16 12 - U-Line Corporation Limited Warranty ......................17 U-Line Use and Care Table of Contents...
Consult the installation guide before any installation begins. U-Line contact information appears on the rear WARNING cover of this guide. SHOCK HAZARD - Electrical Grounding Required.
Black and white models only. Stainless steel model. Offers a bold stainless steel handle, stainless steel wrap door. BI2115 has full wrap. CO1175 has black Field-reversible doors. Flexible installation options. All models "cap" on top and bottom of the door. Stainless steel models must with black and white doors are field-reversible.
1 Product Operation Initial Startup Air Flow All U-Line controls are preset at the factory. Initial startup requires no adjustments. IMPORTANT IMPORTANT The unit requires proper air flow to perform at its highest IMPORTANT IMPORTANT efficiency. Do not block the front grille or internal fans at U-Line recommends allowing the unit to run overnight any time, or the unit will not perform as expected.
• The number of door openings and the time the door is open. • The time the internal light is illuminated. (This mainly affects product on the top rack or shelf.) • The front grille or condenser are obstructed. U-Line Product Operation...
Remove the ice bucket for emptying and cleaning. To remove the ice bucket, raise the bin arm and remove the bucket from the ice compartment. Use the ice bucket for ice storage only. U-Line Ice Maker...
(if equipped) operation. Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1). U-Line Combo® Models and Ice Makers Maintenance...
To install the door shelf: 1. Holding the shelf in the center, center the shelf in the door at the desired location, slightly above the pins (2). 2. Lower the shelf onto the pins (2). U-Line Combo® Models and Ice Makers Maintenance...
Plug Hole 2. Remove corresponding screws on opposite side of cabinet. On some models there may be a nut behind one or both screws on either side. Right Side Left Side Door Swing Door Swing U-Line Standard Door Alignment and Reversal...
Page 12
5. Remove the plastic hinge bushing (2) and install in the corner opposite of where it was removed. Install grille: 6. Remove the U-Line nameplate (3) from door. This will reveal Install the grille, see MAINTENANCE section of this guide. mounting holes for the door actuator bracket.
U-2175WCCOL-00 4. If door edge opposite the hinges needs to move up, move plate toward outside of door(2). If door edge needs to move down, move plate toward inside of door(3). Repeat until top edge of U-Line Self Closing Doors...
1. Install the hinge just removed from the top to the BOTTOM opposite side of the cabinet (three screws) (2). 2. Remove the two door closer inserts (4) from the existing bottom hinge. 3. Install door closer inserts as shown on the new bottom hinge (4). U-Line Self Closing Doors...
5. Reinstall hinge screw pin (1) into top hinge using a Phillips Bottom Of Door screwdriver. Align and adjust the door: Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 10. Pivot Plate Screws U-Line Self Closing Doors...
Page 16
(three screws) (2). 2. Remove the two door closer inserts (4) from the preexisting bottom hinge. Logo Door Orientation Left Hand Hinge 3. Install door closer inserts as shown on the new bottom hinge Logo (4). U-Line Self Closing Doors...
Page 17
4. Hold door to keep it from falling. 5. Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver. Align and adjust the door: Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT on page 10. U-Line Self Closing Doors...
For best inner lining. results use Claire® Stainless Steel Polish and Cleaner, which can be purchased from U-Line Corporation (Part Number 173348). Comparable products are acceptable. Frequent cleaning will remove surface contamination that could lead to rust. Some To defrost: installations may require cleaning weekly.
RISK OF CHILD ENTRAPEMENT. Before you throw away your old refrigerator or freezer, take off the doors and leave shelves in place so children may not easily climb inside. 3. Remove the cabinet door. Icemaker Models Typical Model Shown U-Line Combo® Models and Ice MakersCleaning...
12 Service Troubleshooting Guide Before Calling for Service DANGER If you think your U-Line product is malfunctioning, read the OPERATION section of this guide to clearly understand the ELECTROCUTION HAZARD. Never attempt to repair or function of the control. perform maintenance on the unit until disconnecting the If the problem persists, read the NORMAL OPERATING main electrical power.
E-mail: onlineparts@u-line.com BUILDING ON THREE GENERATIONS OF INNOVATION For nearly five decades and three generations, U-Line continues to be the leader in innovation, quality and value in the premium built-in undercounter ice making, refrigeration and wine preservation market. U-Line has captivated those with an appreciation for the finer things with exceptional functionality, style, inspired innovation and attention to even the smallest details.