Related Manuals for Frigidaire Side Burner
Summary of Contents for Frigidaire Side Burner
- Page 1 Frigidaire Side Burner Built-In Usage USE AND CARE MANUAL FOR OUTDOOR USE ONLY MADE IN THE USA...
-
Page 2: General Safety Instructions
- This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to come in contact with grate, burner or hot surfaces. - Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. -
Page 3: Built-In Instructions
The Frigidaire side burner is designed to be installed as a built-in side burner, in conjunction with a Frigidaire & Frigidaire Gallery grills. If installed as a built-in Grill, the Grill surround must be constructed of Non-combustible material. PLANNING AND DESIGN Start by identifying the number and size of components you want to include in your outdoor cooking center. - Page 4 Additional Requirements: • If using a backsplash apron or rear wall, locate electrical service on the left hand side for rotisserie motor construc- tion. • A minimum clearance of 12” from the back of the outdoor cooking center must be maintained between the grill and any combustible construction such as wood siding of residence, 3”...
-
Page 5: Natural Gas Installation
4. Attach the one end of the flex line to the fitting on the side of the “T” fitting. Connect the other end of the flex line to the side burner valve. (See Fig 4) Note: This line can be extended using a 3/8”... - Page 6 (See Fig. 4) 5. Grasp and remove NG valve assembly from the side burner tube assembly and remove from the side burner. (See Fig. 5) 6. Install LP valve assembly into the side burner. (See Fig. 6) Underside of right side...
- Page 7 9. Reattach the control knob onto the manifold stem. (See Fig. 3, again) 10. Looking down at top of side burner, use a 7mm nut driver to remove the NG. (See Fig. 16. Install the new LP orifice (See Fig. 9) 17.
- Page 8 6. Attach the Flex Line to the fitting on the side of the “T” fitting. Connect the other end of the flex line to the side burner valve. (See Fig. 16) Note: This line can be extended using a 3/8”...
-
Page 9: Installation Instructions
Tools Required: Adjustable wrench, flat head screwdriver and a 1/4” socket wrench Please use the built in information on the following pages for the exact dimensions needed to fit the side burner into the structure. Once installed into the structure use the following steps to complete the side burner installation. -
Page 10: Lighting The Side Burner
Perform a leak test at all connections and fit- tings by spraying a 50/50 solution of water and soap. If any bubbles appear, correct the leak before attempting to light the grill or side burner. LIGHTING INSTRUCTIONS Push and turn the control knob to the “HIGH”position and immediately press and hold the electronic igniter button. -
Page 11: Limited Lifetime Warranty
Provide a replacement for any defective stainless steel burner which prove to be defective in materials or workmanship. All of the provisions of the full and limited warranties above and the exclusions listed below apply.