Honeywell FOCUSPROTM TH5000 Series Installation Manual

Honeywell FOCUSPROTM TH5000 Series Installation Manual

Non-programmable digital thermostat
Hide thumbs Also See for FOCUSPROTM TH5000 Series:
Table of Contents

Advertisement

Available languages

Available languages

FocusPRO
Non-Programmable Digital Thermostat
This manual covers the following models
• TH5110D: For 1 Heat/1 Cool systems
• TH5220D: For up to 2 Heat/2 Cool systems
• TH5320U: For up to 3 Heat/2 Cool systems
(Remove battery holder to find model number)
System Types
• Gas, oil, or electric heat with air
conditioning
• Warm air, hot water, high-
efficiency furnaces, heat pumps,
steam, gravity
Must be installed by a trained, experienced technician
Read these instructions carefully. Failure to follow these instructions
can damage the product or cause a hazardous condition.
For assistance with this product please visit
or call Honeywell Customer Care toll-free at
® U.S. Registered Trademark. Patents pending.
Copyright © 2006 Honeywell International Inc.
All rights reserved.
TH5000 Series
TM
Need Help?
Installation
Guide
• Heat only — two-wire systems,
three-wire zone valves (Series
20), and normally open zone
valves
• Heat only with fan
• Cool only
• 750 mV heating systems
http://yourhome.honeywell.com
1-800-468-1502
69-1922ES

Advertisement

Table of Contents
loading

Summary of Contents for Honeywell FOCUSPROTM TH5000 Series

  • Page 1 Need Help? For assistance with this product please visit http://yourhome.honeywell.com or call Honeywell Customer Care toll-free at 1-800-468-1502 ® U.S. Registered Trademark. Patents pending. Copyright © 2006 Honeywell International Inc. All rights reserved.
  • Page 2: Wallplate Installation

    Installation Guide Wallplate installation 1. Separate wallplate from thermostat. It's easier to grasp the wallplate and remove it after completely 2. Mount wallplate as shown below. removing the battery holder. Remove battery holder. Pull here to remove wallplate from new thermostat. Drill 3/16"...
  • Page 3: Power Options

    FocusPRO TH5110 / TH5220 / TH5320 Power options Keep wires in this shaded area Remove factory- installed jumper only for two- transformer systems. Insert batteries for primary or backup power. Connect for primary AC power (optional if batteries are installed). Wiring Terminal designations Shaded areas below apply only to...
  • Page 4: Wiring Conventional Systems

    L terminal sends a continuous output when Common connection must come from thermostat is set to Em. Heat. Connect cooling transformer. to Honeywell zoning panels to switch the In Installer Setup, set system type to panel to Emergency Heat. Heat Only.
  • Page 5: Heat Pump Systems

    FocusPRO TH5110 / TH5220 / TH5320 Wiring Wiring guide — heat pump systems Shaded areas below apply only to TH5320U/TH5220D or as otherwise noted. 1H/1C Heat 2H/2C Heat Pump System Pump System (TH5320U only) Power Power [R+Rc joined by jumper] [R+Rc joined by jumper] Compressor contactor Compressor contactor (stage 1)
  • Page 6: Installer Setup

    Installation Guide Installer setup Follow the procedure below to configure the thermostat to match the installed heating/cooling system, and customize feature operation as desired. Function Setting number Done Next Press to change settings. Press NEXT to advance to the next function. To begin, press and hold the and FAN Press DONE to exit and save settings.
  • Page 7: Installer System Test

    FocusPRO TH5110 / TH5220 / TH5320 Installer setup Setup function Settings & options (factory default in bold) Shaded areas below apply only to TH5320U/TH5220D or as otherwise noted. Stage 1 compressor Recommended for most compressors cycle rate (CPH) [Other cycle rate options: 1, 2, 4, 5 or 6 CPH] Stage 2 compressor Recommended for most compressors cycle rate (CPH)
  • Page 8: Auxiliary Heat Control

    1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 http://yourhome.honeywell.com Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. ® U.S. Registered Trademark. © 2006 Honeywell International Inc. 69-1922ES M.S. 03-06...
  • Page 9 Para obtener asistencia relacionada con este producto, visite http://yourhome.honeywell.com o comuníquese con el número gratuito del Centro de atención al cliente de Honeywell, llamando al 1-800-468-1502 Marca registrada de los EE. UU. Patentes en trámite. ® © 2006, Honeywell International Inc.
  • Page 10: Instalación De La Placa Para Pared

    Guía de instalación Instalación de la placa para pared 1. Quite la placa para pared del termostato. Es más fácil quitar la placa para pared una vez que 2. Monte la placa para pared como muestra se extrae completamente la ilustración de abajo. el soporte de la batería.
  • Page 11 FocusPRO TH5110 / TH5220 / TH5320 Opciones de fuentes de energía Mantenga los cables en esta área Quite el puente sombreada instalado en la fábrica sólo en los sistemas con dos transformadores. Coloque las baterías para suministro de energía principal o de respaldo. Conecte para suministrar corriente CA (opcional si las baterías están instaladas).
  • Page 12 Durante la configuración de instalación, posición Em. Heat. Conéctelo a los paneles coloque el tipo de sistema en “Heat Only”. de separación de Honeywell para cambiar Durante la configuración de instalación, a Em. Heat. coloque el tipo de sistema en Convencional...
  • Page 13: Montaje Del Termostato

    FocusPRO TH5110 / TH5220 / TH5320 Cableado Guía de cableado: sistemas de bomba de calor Las áreas sombreadas que aparecen abajo sólo se utilizan para los modelos TH5320U y TH5220D o según se indique. Sistema de bomba de Sistema de bomba de calor de 1 calentador calor de 2 calentadores y 1 refrigerador...
  • Page 14: Configuración De Instalación

    Guía de instalación Configuración de instalación Siga el procedimiento que aparece a continuación para configurar el termostato a fin de que se corresponda con el sistema de calefacción y refrigeración instalado, y seleccione las funciones según lo desee. Configuración Número de función DONE NEXT Presione...
  • Page 15: Prueba Del Sistema

    FocusPRO TH5110 / TH5220 / TH5320 Configuración de instalación Funciones de la Configuraciones y opciones (las que vienen configuración desde la fábrica aparecen en negrita) Las áreas sombreadas que aparecen abajo sólo se utilizan para los modelos TH5320U y TH5220D o según se indique.
  • Page 16: Funciones Especiales

    Golden Valley, MN 55422 Scarborough, Ontario M1V4Z9 http://yourhome.honeywell.com Impreso en los EE. UU., en papel reciclado que contiene por lo menos un 10% de fibras de papel reciclable. ® Marca registrada de los EE. UU. © 2006, Honeywell Internacional Inc. 69-1922ES M.S. 03-06...

This manual is also suitable for:

Focuspro th5110dFocuspro th5220dFocuspro th5320u

Table of Contents