Honeywell Q682A Installation Instructions Manual page 4

MOUNT THE THERMOSTAT
Note the tabs on the top inside edge of the thermostat
base. These tabs fit the slots molded into the top of the
subbase.
Hang thermostat base on subbase.
Insert the two captive mounting screws located in the
bottom corners of the base (Fig. 6).
Firmly tighten the screws.
Fig. 6—Thermostat mounting.
TAB (2)
MOUNTING SLOT (2)
1
35
30
2 0
WALLPLATE
THERMOSTAT
BASE OR SUBBASE
INSERT TIMER BATTERIES
Power is supplied to the timer by two AAA alkaline
batteries (not included).
Install the batteries in the thermostat (Fig. 7).
Once a year or when batteries are dead, replace with two
new AAA alkaline batteries. We recommend Energizer
batteries.
Fig. 7—Insert timer batteries.
BATTERY LOCATION FOR
(2) AAA BATTERIES;
INSTALL WITH POSITIVE
ENDS UP
69-0637—2
SET TIMER
Do NOT reverse the knob.
nighttime (dark) portion of the program dial.
ATTACH THERMOSTAT COVER
removed.
CAPTIVE
MOUNTING SCREWS
M8674
mounting slots in the thermostat base (Fig. 9).
of the base.
®
SET TEMPERATURE CONTROL LEVERS
high temperatures for energy savings and comfort control
(Fig. 10). The lever on the left (blue mark) controls the
lower temperature. The lever on the right (red mark) con-
trols the higher temperature.
priate temperature for either heat or cool until the occupant
M8585
programs the thermostat and makes the final temperature
selections.
4
Adjust the timer by moving the knob clockwise
When time is correctly set, the time indicator arrow
(Fig. 8) must point to the corresponding daytime (light) or
Fig. 8—Set timer.
Make sure the packing inserts in the thermostat base are
Place the two tabs on the upper edge of the cover into the
Swing the cover downward until it catches at the bottom
Fig. 9—Attach cover.
The two levers on top of thermostat control the low and
We recommend pushing the levers together at an appro-
.
PROGRAM
PINS (4)
SEE OWNER'S
MANUAL FOR
DETAILS
TIMER
SETTING
KNOB
TIME
INDICATOR
ARROW
M5161
M8604