Related Manuals for NEC SuperScript 4400 series
Summary of Contents for NEC SuperScript 4400 series
- Page 1 S U P E R S C R I P T 4 4 0 0 S E R I E S USER’S GUIDE Contents Index February, 1999 703-A0323-001...
- Page 2 NEC disclaims any responsibility for specifying which marks are owned by The NEC Technologies product(s) discussed in this document which companies or organizations. are warranted in accordance with the terms of the Limited Warranty Statement accompanying each product.
-
Page 3: About This Addendum
This addendum revises information in the September, 1998, The left column identifies which page in the User’s Guide is edition of the NEC SuperScript 4400 Series User’s Guide. effected. The center column identifies which page in this addendum the revision can be found. The right column identifies the name of the revised subject. - Page 4 SuperScript 4400 User’s Guide — Addendum...
-
Page 5: Table Of Contents
Color Control Options ......3 NEC Premium Paper Sampler ....8 Windows 95/98 . - Page 6 SuperScript 4400 User’s Guide — Addendum...
-
Page 7: Evisions To The
OADING THE APER Listed below are subjects that revises information in the NEC SuperScript 4400 Series User’s Guide, and are listed in Revises page 19 of the User’s Guide. the order in which they are presented in the User’s Guide. -
Page 8: Preparing The Printer
Preparing the Printer Installing the NIC 1. Turn off the printer. Disconnect the power cord and Remove the NIC from its protective bag (E). Handle the parallel printer cable from the interface panel (A). NIC only by its edges. Position the printer so that the interface panel can be Position the NIC as shown in (F), then plug the NIC’s accessed. -
Page 9: Testing The Nic
The ICM based driver calibrates the colors with those to 100 Mbps networks. actually seen on the print client’s monitor. The NEC based 2. Use the power cord to interconnect the printer with a driver calibrates the colors with those described by the NEC power source. -
Page 10: Windows 95/98
Installing the Printer Driver To install the Windows 95/98 printer driver from the SuperScript 4400 Series CD: 1. Insert the SuperScript 4400 Series CD into the CD-ROM drive. The Installer will launch automatically. Following the instructions displayed on the computer monitor. -
Page 11: Resetting The Nic
Microsoft Word, Excel, and PowerPoint. Press Select, and when the panel displays PARAMETERS • The web server included on the SuperScript 4400 Series press Select again. Installer CD, which is automatically installed when pull/ printing/server is selected under the Administration installation. -
Page 12: Using Map
To install the non-ICM based driver, move to the ps95 Installing MAP directory and select ncss4400.inf . MAP is available on the SuperScript 4400 Series CD that comes Click Next . with your printer. It must be installed from Windows 95/98 5. -
Page 13: Removing Peer-To-Peer Software
RINTING ROBLEMS these steps. Added to Chapter 9, “Troubleshooting.” Insert the SuperScript 4400 Series CD into the CD-ROM drive. This section describes solutions to problems that might From the Windows Start button and select Run to open appear when a computer is locally connected (with a parallel the Run dialog box. -
Page 14: Solutions For Unix Computers
Press SELECT and COMMUNICATIONS PARALLEL (NEC Order No. 70-520) will appear. PORT NEC Premium Paper Sampler: Press SELECT. A sampler is available that contains a selection of all the NEC Press NEXT until appears. BIDI Premium Papers. Press SELECT and will appear. -
Page 15: Index
Click on a page number to go to that subject. Pull Printing Server Requirements Color Control Options Remote Printing Image Color Matching (ICM) transparencies installing Windows 3.1x Windows 95/98 NEC PrintAgent Driver Installation Windows NT shared driver Installing configure for sharing Preparing the Printer description resetting installing Testing... - Page 16 NEC Technologies, Inc. 1250 N. Arlington Heights Rd. Itasca, IL 60143 www.nectech.com P/N: 703-A0323-001...