Frost free fridge-freezer with ice cube maker and dynamiccooling (68 pages)
Summary of Contents for Miele KFN 8767 S ed-2
Page 1
Operating and installation instructions Frost free fridge freezer with StayFresh compartment KFN 8767 S ed-2 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed or used for the first time.
Guide to the appliance a On button for switching the whole f Master switch for switching appliance on, and the whole appliance on and off On/Off button for independently g Freezer section temperature display switching the refrigerator section and h Freezer section StayFresh zone on and off.
Page 6
Guide to the appliance k Butter and cheese compartment l Shelf m Egg tray n Interior lighting o Fruit and vegetable containers p Bottle divider* q Bottle shelf r Condensate channel and drain hole s StayFresh zone, dry compartment t Control for setting the moisture level in the humidity controlled compartment u StayFresh zone, humidity controlled...
Miele{home Optional accessory The Miele|home system gives you the ability to check information about your appliance at any time. For example, if a temperature alarm, power cut or other fault message occurs, this information will be relayed directly to the Miele|home system.
Caring for the environment Disposal of the packing Disposal of your old appliance material Please ensure that the appliance presents no danger to children while The transport and protective packing being stored for disposal. has been selected from materials which are environmentally friendly for It should be unplugged or disposal, and can normally be...
Warning and Safety instructions Technical safety This appliance complies with all This appliance contains the coolant relevant legal safety requirements. Isobutane (R600a), a natural gas Improper use can, however, present which is environmentally friendly. a risk of both personal injury and Although it is flammable, it does not material damage.
Page 10
Warning and Safety instructions Before connecting the appliance to Installation work, maintenance and the mains supply, make sure that repairs may only be carried out by the rating on the data plate suitably qualified and competent corresponds to the voltage and persons in accordance with national frequency of the household supply.
Page 11
Warning and Safety instructions Do not allow children to play with Observe the "use by" dates given the appliance, for example to climb on food to avoid the risk of food inside the drawers or to swing on the poisoning. door.
Warning and Safety instructions Disposal of your old appliance Do not block the ventilation gaps in the appliance as this would impair Before disposing of an old the efficiency of the appliance, increase appliance, first make the door latch the electricity consumption and could or lock unusable.
How to save energy Normal energy consumption Increased energy consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source Situated near to a heat source (radiator, oven).
Page 14
How to save energy Normal energy Increased energy consumption consumption Defrosting Defrost the freezer when a layer of A layer of ice hinders the cold ice one centimetre thick has built from reaching the frozen food, and causes an increase in energy consumption.
Switching on and off Before using for the first time Bars light up in the freezer section temperature display. The stainless steel surface and the The appliance starts cooling. shelf trims have a protective cover to prevent scratching during Allow the appliance to run for a few transportation.
Switching on and off ^ Press the Super freeze button to save To switch the refrigerator section / the setting. StayFresh zone back on again ^ Press the On/Off button on the left The safety lock indicator light will hand side of the control panel again. light up when the safety lock has been activated.
The correct temperature . . . in the freezer section It is very important to set the correct temperature for storing food in the To freeze fresh food and to store frozen appliance. Micro-organisms will cause food for a long time, a temperature food which is not stored at the correct colder than -18 °C is required.
The correct temperature Setting the temperature in the When pressing the buttons, the following information shows in the StayFresh zone display: The temperature in the StayFresh zone – When first pressed, the last is automatically held at 0 to 3 °C. It can temperature selected flashes.
The correct temperature Temperature display During normal operation the temperature displays on the control panel show the temperature in the ^ Press the master switch on the right middle of the refrigerator section and hand side of the control panel to the temperature in the warmest part of come out of the setting mode.
The correct temperature Temperature display brightness The appliance is supplied with the brightness of the temperature display set as low as possible. However, if the ^ Press the master switch on the right door is opened, a setting changed or if hand side of the control panel to the alarm is sounding, the temperature come out of the setting mode.
Alarm Switching on the alarm system Your appliance has been fitted with a warning system which ensures that the The alarm system is always active. It temperature in the freezer section does not have to be switched on cannot rise unnoticed. manually.
Super cool and Super freeze Super cool Freezing fresh food The Super cool function can be used to Fresh food should be frozen as quickly rapidly reduce the temperature in the as possible. This way the nutritional refrigerator section to its lowest setting value of the food, its vitamin content, (depending on the room temperature).
Super cool and Super freeze Super freeze Switching off Super freeze Switch the Super freeze function on Depending on the amount of food before putting fresh food into the placed in the freezer section, the Super freezer section. freeze function will switch off automatically after approx.
Using the refrigerator section efficiently Different storage zones Do not store explosive materials in Due to the natural circulation of the air the appliance or any products in the appliance, there are different containing propellants (e.g. spray temperature zones in the refrigerator cans).
Using the refrigerator section efficiently High humidity level - The StayFresh zone is divided into two areas: ^ To set a humidity level of approx. – The dry compartment has a relative 90 % slide the control for the humidity humidity level of approx.
Using the refrigerator section efficiently Storing food correctly Different types of unpacked meats and vegetables must be kept Store food covered or packaged. This separate. will prevent food smells or tastes from affecting other foods, and prevent food To avoid any microbiological from drying out and also any cross-contamination, these foods may cross-contamination of bacteria.
Adjusting the interior fittings Moving the shelves Adjusting the door shelves ^ Push the door shelf upwards, then The shelves can be adjusted according to the height of the food. remove it by pulling it forwards. ^ Pull the shelves forward as far as ^ Replace the door shelf at the they will go;...
Freezing and storing food Maximum freezing capacity Home freezing To ensure that fresh food placed in the Only freeze fresh food which is in a freezer freezes through to the core as good condition. quickly as possible, the maximum freezing capacity must not be Hints on home freezing exceeded.
Freezing and storing food ^ Make a note of the contents and the – Do not season fresh foods or blanched vegetables before date of freezing on the packaging. freezing. Only season cooked food lightly before freezing but care Before placing food in the freezer should be taken as the taste of some section spices alters when frozen.
Freezing and storing food ^ Place the food flat in the bottom of ^ Slide the markers onto the guide the drawers or on the glass cold runners on the edge of the drawers. plates so that it freezes through to the Use the markers to indicate the type of core as quickly as possible.
Freezing and storing food Cooling drinks Never re-freeze partially or fully Drinks are best cooled quickly in the defrosted food. Consume defrosted refrigerator section using the Super food as soon as possible as it will cool function. If bottles are, however, lose its nutritional value and spoil if placed in the freezer section for rapid left for too long.
Freezing and storing food Cool pack The cool pack prevents the temperature in the freezer rising too quickly in the event of a power cut. Place the cool pack in the upper drawer directly on top of food or to save space on the freezer tray.
Defrosting Refrigerator section and Freezer section StayFresh zone This freezer is equipped with a "Frost free" system. The freezer defrosts Condensate and frost can build up on automatically. the back wall of the refrigerator section and the StayFresh zone whilst in use. The moisture generated by defrosting These are automatically removed and collects in the condenser and is...
^ A microfibre "E-Cloth" is available in the event of a service call. from the Miele UK Spare Parts Before cleaning Department, which is suitable for cleaning surfaces such as stainless ^ Switch the appliance off by pressing...
Cleaning and care Ventilation gaps After cleaning ^ The ventilation gaps should be ^ Replace all shelves and accessories cleaned regularly with a brush or in the refrigerator section and the vacuum cleaner. A build-up of dust StayFresh zone. will increase the energy consumption ^ Place food back in the refrigerator of the appliance.
^ Check that the fuse is not defective ^ Check whether, the metal grille (heat and that the mains fuse has not blown. If it has, contact the Miele Ser- exchanger) at the back of the vice Department. appliance has become too dusty.
Page 37
Problem solving guide ... the compressor is running Once the problem has been resolved the freezer section temperature display constantly will light up constantly and the alarm When the appliance is sufficiently cold will go off. inside, the compressor will switch on for longer, but at a low setting to save .
Page 38
Problem solving guide The warmest temperature will show in the display for about 1 minute. The display will then revert to showing the current temperature in the freezer section. At the end of a power cut, the appliance will start operating again at the last temperature setting selected.
Page 39
Problem solving guide If you still cannot remedy the fault having followed these suggestions, please contact the Miele Service Department. To prevent unnecessary loss of temperature it is advisable not to open the door while waiting for the appliance to be serviced.
Noises Normal noises What causes them Humming noise made by the motor (compressor). This noise can Brrrrr... get louder for brief periods when the motor is switching on. Blubb, blubb..A gurgling noise can be heard when coolant is circulating through the pipes.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer – the Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
Electrical connection Electrical connection U.K. Non-rewireable plugs (BS 1363) All electrical work should be carried out The fuse cover must be re-fitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person in accordance with local and is lost, the plug must not be used until a national safety regulations.
Installation Do not place any appliance which Climate range Ambient room temperature gives off heat, such as a toaster or microwave oven, on top of this +10 °C to +32 °C +16 °C to +32 °C appliance, as this would increase +18 °C to +38 °C the appliance’s energy consumption.
Changing the door hinging ^ Remove the cover caps from the The appliance is supplied right hand hinged. If left hand door hinging is opposite side, and fit them into the required, follow the instructions below. empty holes. Removing the door handles: Changing over the doors: ^ Open the lower door.
Page 46
Changing the door hinging ^ Open the upper door, and pull it ^ Pull bearing bush o downwards out of hinge bracket n and refit it from downwards and off. above into the hinge bracket. ^ Remove spacer p with a screwdriver and refit it on the opposite side.
Page 47
Changing the door hinging Refitting the handles: In the following illustration the lower door is not shown in the closed Please make sure you follow the position to make it easier to see instructions below carefully when what happens next. you refit the handle.
Changing the door hinging It is important to check that the side section of the handle d does not come into contact with the door seal when opening the door, as this would damage the door seal permanently. ^ To put the compartment back in, pull the runners a right out and place the If, after you have refitted the handle, you find that the side section does...
Building in the appliance The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. When built into a kitchen run (max. depth 580 mm) the appliance can be installed directly next to a kitchen furniture housing unit.
Page 52
Alteration rights reserved / 1905 M.-Nr. 06 534 380 / 01 en - GB KFN 8767 S ed-2...