Depth Alignment; Dismantling - Miele DA 262 i Operating Instructions Manual

Installation

Depth alignment

Units deeper than 285 mm require the
fitting of a spacer bar to prevent va-
pours collecting between the rear of
the cooker hood and the wall.
2
1
To achieve the correct depth shorten
the
– spacer bar at the required breaking
points.
– End caps.
Fit the end caps (1) to both ends of
the spacer bar.
Attach the spacer bar to the guide
rail (2) located behind the light tube.
Fitting the light tube cover
– DA 262 i
Position the light tube cover and
screw into place (see diagram).
1
– DA 272 i, DA 292 i
Attach the extension pieces supplied
to the light tube cover, then postion
the now extended light tube cover
and screw into place.

Dismantling

Disconnect the appliance from the elec-
tricity supply by unplugging at the
socket, or removing the mains fuse.
Take the dividing wall out of the wall
unit.
Release the hose clip from the ex-
haust connection and push the hose
upwards.
Loosen the securing screws used to
screw the cooker hood to the side walls.
Note
The two holding screws must not be
removed. These must be left in the
unit as otherwise the cooker hood
could drop down onto the hob.
Pull the deflector plate out to its limit
and remove the grease filters.
Remove the screws now visible
(DA 262 i / DA 272 i = 4;
DA 292 i = 6) using a Philips screw-
driver.
Lift the cooker hood off the holding
screws and take it out from below.
Installation
23